/* * Copyright (c) 1980, 1986 Regents of the University of California. * All rights reserved. * * Redistribution and use in source and binary forms are permitted * provided that the above copyright notice and this paragraph are * duplicated in all such forms and that any documentation, * advertising materials, and other materials related to such * distribution and use acknowledge that the software was developed * by the University of California, Berkeley. The name of the * University may not be used to endorse or promote products derived * from this software without specific prior written permission. * THIS SOFTWARE IS PROVIDED ``AS IS'' AND WITHOUT ANY EXPRESS OR * IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED * WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE. * * @(#)netisr.h 7.4 (Berkeley) 06/27/88 */ /* * The networking code runs off software interrupts. * * You can switch into the network by doing splnet() and return by splx(). * The software interrupt level for the network is higher than the software * level for the clock (so you can enter the network in routines called * at timeout time). */ #if defined(vax) || defined(tahoe) #define setsoftnet() mtpr(SIRR, 12) #endif /* * Each ``pup-level-1'' input queue has a bit in a ``netisr'' status * word which is used to de-multiplex a single software * interrupt used for scheduling the network code to calls * on the lowest level routine of each protocol. */ #define NETISR_RAW 0 /* same as AF_UNSPEC */ #define NETISR_IP 2 /* same as AF_INET */ #define NETISR_IMP 3 /* same as AF_IMPLINK */ #define NETISR_NS 6 /* same as AF_NS */ #define schednetisr(anisr) { netisr |= 1<<(anisr); setsoftnet(); } #ifndef LOCORE #ifdef KERNEL int netisr; /* scheduling bits for network */ #endif #endif