xref: /original-bsd/sys/vax/if/if_ilreg.h (revision 89f4d471)
1 /*
2  * Copyright (c) 1982, 1986 Regents of the University of California.
3  * All rights reserved.
4  *
5  * %sccs.include.redist.c%
6  *
7  *	@(#)if_ilreg.h	7.3 (Berkeley) 06/28/90
8  */
9 
10 /*
11  * Interlan Ethernet Communications Controller interface
12  */
13 struct ildevice {
14 	short	il_csr;		/* Command and Status Register */
15 	short	il_bar;		/* Buffer Address Register */
16 	short	il_bcr;		/* Byte Count Register */
17 };
18 
19 /*
20  * Command and status bits
21  */
22 #define	IL_EUA		0xc000		/* Extended Unibus Address */
23 #define	IL_CMD		0x3f00		/* Command Function Code */
24 #define	IL_CDONE	0x0080		/* Command Done */
25 #define	IL_CIE		0x0040		/* Command Interrupt Enable */
26 #define	IL_RDONE	0x0020		/* Receive DMA Done */
27 #define	IL_RIE		0x0010		/* Receive Interrupt Enable */
28 #define	IL_STATUS	0x000f		/* Command Status Code */
29 
30 #define	IL_BITS		"\20\10CDONE\7CIE\6RDONE\5RIE"
31 
32 /* command definitions */
33 #define	ILC_MLPBAK	0x0100		/* Set Module Interface Loopback Mode */
34 #define	ILC_ILPBAK	0x0200		/* Set Internal Loopback Mode */
35 #define	ILC_CLPBAK	0x0300		/* Clear Loopback Mode */
36 #define	ILC_PRMSC	0x0400		/* Set Promiscuous Receive Mode */
37 #define	ILC_CLPRMSC	0x0500		/* Clear Promiscuous Receive Mode */
38 #define	ILC_RCVERR	0x0600		/* Set Receive-On-Error Bit */
39 #define	ILC_CRCVERR	0x0700		/* Clear Receive-On-Error Bit */
40 #define	ILC_OFFLINE	0x0800		/* Go Offline */
41 #define	ILC_ONLINE	0x0900		/* Go Online */
42 #define	ILC_DIAG	0x0a00		/* Run On-board Diagnostics */
43 #define	ILC_ISA		0x0d00		/* Set Insert Source Address Mode */
44 #define	ILC_CISA	0x0e00		/* Clear Insert Source Address Mode */
45 #define	ILC_DEFPA	0x0f00		/* Set Physical Address to Default */
46 #define	ILC_ALLMC	0x1000		/* Set Receive All Multicast Packets */
47 #define	ILC_CALLMC	0x1100		/* Clear Receive All Multicast */
48 #define	ILC_STAT	0x1800		/* Report and Reset Statistics */
49 #define	ILC_DELAYS	0x1900		/* Report Collision Delay Times */
50 #define	ILC_RCV		0x2000		/* Supply Receive Buffer */
51 #define	ILC_LDXMIT	0x2800		/* Load Transmit Data */
52 #define	ILC_XMIT	0x2900		/* Load Transmit Data and Send */
53 #define	ILC_LDGRPS	0x2a00		/* Load Group Addresses */
54 #define	ILC_RMGRPS	0x2b00		/* Delete Group Addresses */
55 #define	ILC_LDPA	0x2c00		/* Load Physical Address */
56 #define	ILC_FLUSH	0x3000		/* Flush Receive BAR/BCR Queue */
57 #define	ILC_RESET	0x3f00		/* Reset */
58 
59 /*
60  * Error codes found in the status bits of the csr.
61  */
62 #define	ILERR_SUCCESS		0	/* command successful */
63 #define	ILERR_RETRIES		1	/* " " with retries */
64 #define	ILERR_BADCMD		2	/* illegal command */
65 #define	ILERR_INVCMD		3	/* invalid command */
66 #define	ILERR_RECVERR		4	/* receiver error */
67 #define	ILERR_BUFSIZ		5	/* buffer size too big */
68 #define	ILERR_FRAMESIZ		6	/* frame size too small */
69 #define	ILERR_COLLISIONS	8	/* excessive collisions */
70 #define	ILERR_BUFALIGNMENT	10	/* buffer not word aligned */
71 #define	ILERR_NXM		15	/* non-existent memory */
72 
73 #define	NILERRS			16
74 #ifdef ILERRS
75 char *ilerrs[NILERRS] = {
76 	"success",			/*  0 */
77 	"success with retries", 	/*  1 */
78 	"illegal command",		/*  2 */
79 	"inappropriate command",	/*  3 */
80 	"failure",			/*  4 */
81 	"buffer size exceeded",		/*  5 */
82 	"frame too small",		/*  6 */
83 	0,				/*  7 */
84 	"excessive collisions",		/*  8 */
85 	0,				/*  9 */
86 	"buffer alignment error",	/* 10 */
87 	0,				/* 11 */
88 	0,				/* 12 */
89 	0,				/* 13 */
90 	0,				/* 14 */
91 	"non-existent memory"		/* 15 */
92 };
93 #endif
94 
95 /*
96  * Diagnostics codes.
97  */
98 #define	ILDIAG_SUCCESS		0	/* no problems */
99 #define	ILDIAG_CHKSUMERR	1	/* ROM/RAM checksum error */
100 #define	ILDIAG_DMAERR		2	/* DMA not working */
101 #define	ILDIAG_XMITERR		3	/* xmit circuitry failure */
102 #define	ILDIAG_RECVERR		4	/* rcvr circuitry failure */
103 #define	ILDIAG_LOOPBACK		5	/* loopback test failed */
104 
105 #define	NILDIAGS		6
106 #ifdef ILDIAGS
107 char *ildiag[NILDIAGS] = {
108 	"success",			/* 0 */
109 	"checksum error",		/* 1 */
110 	"NM10 dma error",		/* 2 */
111 	"transmitter error",		/* 3 */
112 	"receiver error",		/* 4 */
113 	"loopback failure",		/* 5 */
114 };
115 #endif
116 
117 /*
118  * Frame status bits, returned in frame status byte
119  * at the top of each received packet.
120  */
121 #define	ILFSTAT_C	0x1		/* CRC error */
122 #define	ILFSTAT_A	0x2		/* alignment error */
123 #define	ILFSTAT_L	0x4		/* 1+ frames lost just before */
124