| /freebsd/sys/contrib/device-tree/Bindings/nvmem/ |
| H A D | nvmem-consumer.yaml | 27 Names for the each nvmem provider.
31 Names for each nvmem-cells specified.
|
| /freebsd/sys/contrib/device-tree/Bindings/reset/ |
| H A D | reset.txt | 23 the DT node of each affected HW block, since if activated, an unrelated block
29 rather than to slavishly enumerate the reset signal that affects each HW
49 for each reset signal that affects the device, or that the
73 This represents a bus that controls the reset signal of each of four sub-
|
| /freebsd/crypto/openssl/doc/man1/ |
| H A D | openssl-engine.pod.in | 42 Provides information about each specified engine. The first flag lists
44 description of each command; the third adds the input flags, and the
49 Lists the capabilities of each engine.
53 Tests if each specified engine is available, and displays the answer.
|
| /freebsd/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | xlnx,gpio-xilinx.yaml | 15 a single or a dual-channel device. The width of each channel is
36 description: strings describing the names of each gpio line
110 of each bit of GPIO channel1.
115 of each bit of GPIO channel2.
|
| H A D | snps,dw-apb-gpio.yaml | 11 each of which are intended to be represented as child nodes with the generic
88 one interrupt for each GPIO, provide a list of interrupts that
89 correspond to each of the GPIO pins.
|
| /freebsd/sys/contrib/device-tree/Bindings/sound/ |
| H A D | mt8183-afe-pcm.txt | 7 - resets: Must contain an entry for each entry in reset-names
12 - clocks: Must contain an entry for each entry in clock-names
|
| H A D | sirf-usp.txt | 7 - dma-names: Identifier string for each DMA request line in the dmas property.
15 - pinctrl-NNN: One property must exist for each entry in pinctrl-names.
|
| H A D | brcm,bcm63xx-audio.txt | 9 - clocks: Must contain an entry for each entry in clock-names.
11 - clock-names: One of each entry matching the clocks phandles list:
|
| H A D | cirrus,madera.yaml | 36 A list of input mode settings for each input. A maximum
56 Mono bit for each output, maximum of six cells if the array
69 to DMICs on each input, one cell per input.
90 has multiple data lines. One cell for each AIF, use a value
|
| H A D | img,parallel-out.txt | 11 - dmas: Contains an entry for each entry in dma-names.
16 - clocks : Contains an entry for each entry in clock-names.
|
| H A D | img,spdif-in.txt | 11 - dmas: Contains an entry for each entry in dma-names.
16 - clocks : Contains an entry for each entry in clock-names
|
| H A D | img,spdif-out.txt | 11 - dmas: Contains an entry for each entry in dma-names.
16 - clocks : Contains an entry for each entry in clock-names.
|
| /freebsd/sys/contrib/device-tree/Bindings/mux/ |
| H A D | mux-controller.txt | 7 multiplexer needed by each consumer, but a single mux controller can of course
28 each mux controller property must be documented in the device tree binding for
29 each consumer. An optional property "mux-control-names" may contain a list of
30 strings to label each of the mux controllers listed in the "mux-controls"
130 idle-state property is an array with one idle state for each mux controller.
|
| /freebsd/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | pinmux-node.yaml | 46 pin controller instances, naming each pin and function can easily become
69 one exception. There is no need to specify the phandle for each entry as that
72 currently work as the pinctrl framework uses named modes to group pins for each
81 each single pin the number of required sub-nodes containing "pin" and
90 The pinmux property accepts an array of pinmux groups, each of them describing
|
| /freebsd/sys/contrib/device-tree/Bindings/regulator/ |
| H A D | 88pm800.txt | 6 - regulators: A node that houses a sub-node for each regulator within the
9 The content of each sub-node is defined by the standard binding for
|
| /freebsd/sys/contrib/device-tree/Bindings/timer/ |
| H A D | ti,keystone-timer.txt | 6 timers, each half can operate in conjunction (chain mode) or independently
7 (unchained mode) of each other.
|
| /freebsd/sys/contrib/device-tree/Bindings/phy/ |
| H A D | phy-tegra194-p2u.txt | 4 Speed) each interfacing with 12 and 8 P2U instances respectively.
11 - reg: Should be the physical address space and length of respective each P2U
|
| H A D | phy-miphy365x.txt | 11 an entry for each port sub-node, specifying the control
14 Required nodes : A sub-node is required for each channel the controller
25 - reg : Address and length of register sets for each device in
|
| /freebsd/bin/sh/ |
| H A D | profile | 15 # Load each .sh file in /etc/profile.d/, then /usr/local/etc/profile,
16 # then each .sh file in /usr/local/etc/profile.d/.
|
| /freebsd/sys/contrib/device-tree/Bindings/iommu/ |
| H A D | msm,iommu-v0.txt | 5 of the CPU, each connected to the IOMMU through a port called micro-TLB.
20 for information about the format. For each clock specified
37 and multiple contexts in each of the iommu. So multiple entries
|
| /freebsd/sys/contrib/device-tree/Bindings/hwmon/ |
| H A D | aspeed-pwm-tacho.txt | 31 Under fan subnode there can upto 8 child nodes, with each child node
32 representing a fan. If there are 8 fans each fan can have one PWM port and
37 Required properties for each child node:
|
| /freebsd/contrib/ntp/scripts/stats/ |
| H A D | README.stats | 10 clockstats, each of which is described in this note.
17 reception of each valid update from a configured peer.
33 script for further information. A line in the file is produced at each
50 further information. A line in the file is produced at each valid update
52 several radios. The first part of each data line is similar for all
65 timecode formats specific to each radio follow. See the file
96 The format of each data line returned is summarized in the following
|
| /freebsd/sys/contrib/device-tree/Bindings/input/touchscreen/ |
| H A D | ti-tsc-adc.txt | 15 programmable steps each step is used to
54 ti,chan-step-opendelay: List of open delays for each channel of
61 ti,chan-step-sampledelay: List of sample delays for each channel
67 ti,chan-step-avg: Number of averages to be performed for each
|
| /freebsd/sys/contrib/device-tree/Bindings/spi/ |
| H A D | nvidia,tegra20-sflash.txt | 9 - resets : Must contain an entry for each entry in reset-names.
13 - dmas : Must contain an entry for each entry in clock-names.
|
| /freebsd/sys/contrib/device-tree/Bindings/power/supply/ |
| H A D | cpcap-charger.txt | 5 - interrupts: Interrupt specifier for each name in interrupt-names
10 - io-channels: IIO ADC channel specifier for each name in io-channel-names
|