| /freebsd/sys/contrib/device-tree/src/arm/marvell/ |
| H A D | armada-388-clearfog.dtsi | 153 output-low;
171 output-low;
193 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| /freebsd/sys/contrib/device-tree/Bindings/serial/ |
| H A D | fsl-lpuart.txt | 1 * Freescale low power universal asynchronous receiver/transmitter (lpuart)
28 - rs485-rts-active-low, linux,rs485-enabled-at-boot-time: see rs485.txt
|
| /freebsd/sys/contrib/device-tree/Bindings/display/bridge/ |
| H A D | ite,it66121.yaml | 14 The IT66121 is a high-performance and low-power single channel HDMI
29 description: GPIO connected to active low reset
|
| /freebsd/sys/contrib/device-tree/Bindings/sound/ |
| H A D | ti,pcm3168a.yaml | 36 GPIO line connected to the active-low RST pin of the codec.
37 RST = low: device power-down
|
| /freebsd/sys/contrib/device-tree/src/arm64/renesas/ |
| H A D | rzg2l-smarc-pinfunction.dtsi | 24 output-low;
37 output-low;
|
| /freebsd/sys/contrib/device-tree/src/arm/nxp/imx/ |
| H A D | imx6q-gk802.dts | 76 /* Recovery button, active-low */
78 /* RTL8192CU enable GPIO, active-low */
|
| /freebsd/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | fsl-imx-gpio.yaml | 60 If two numbers, the first one is the interrupt shared by low 16 pins
91 output-low: true
|
| /freebsd/sys/contrib/device-tree/Bindings/media/i2c/ |
| H A D | ovti,ov4689.yaml | 48 GPIO connected to the powerdown pin (active low)
53 GPIO connected to the reset pin (active low)
|
| /freebsd/sys/contrib/device-tree/Bindings/hwmon/ |
| H A D | adi,max31827.yaml | 44 - 0 = active low
60 is low for more than 30ms (nominal).
|
| /freebsd/sys/dev/smbus/ |
| H A D | smbus.h | 41 void smbus_generic_intr(device_t dev, u_char devaddr, char low, char high, int err);
|
| /freebsd/usr.bin/rpcinfo/ |
| H A D | rpcinfo.c | 404 minvers = rpcerr.re_vers.low;
419 minvers = rpcerr.re_vers.low;
506 if (err.re_vers.low > PMAPVERS) {
721 if (err.re_vers.low == RPCBVERS4) {
732 int high, low; local
774 low = pmaphead->pml_map.pm_port & 0xff;
778 high, low);
1301 minvers = rpcerr.re_vers.low;
1315 minvers = rpcerr.re_vers.low;
1408 minvers = rpcerr.re_vers.low;
[all …]
|
| /freebsd/sys/kern/ |
| H A D | kern_resource.c | 98 int error, low; in kern_getpriority() local
101 low = PRIO_MAX + 1; in kern_getpriority()
105 low = td->td_proc->p_nice; in kern_getpriority()
111 low = p->p_nice; in kern_getpriority()
133 if (p->p_nice < low) in kern_getpriority()
134 low = p->p_nice; in kern_getpriority()
150 if (p->p_nice < low) in kern_getpriority()
151 low = p->p_nice; in kern_getpriority()
162 if (low == PRIO_MAX + 1 && error == 0) in kern_getpriority()
164 td->td_retval[0] = low; in kern_getpriority()
|
| /freebsd/sys/contrib/device-tree/src/arm64/qcom/ |
| H A D | apq8016-sbc.dtsi | 393 qcom,mbhc-vthreshold-low = <75 150 237 450 500>;
700 output-low;
773 output-low;
791 output-low;
798 output-low;
816 output-low;
824 output-low;
|
| H A D | sc7280-idp.dtsi | 685 * maintain a low power state regardless of whether
759 output-low;
772 output-low;
790 * maintain a low power state regardless of whether
801 * Configure pull-down on RTS. As RTS is active low
802 * signal, pull it low to indicate the BT SoC that it
804 * pulling RX low (by sending wakeup bytes).
|
| /freebsd/sys/dev/acpica/ |
| H A D | acpi_resource.c | 551 uint64_t low, uint64_t high,
556 uint64_t low, uint64_t high,
672 acpi_res_set_iorange(device_t dev, void *context, uint64_t low, in acpi_res_set_iorange() argument
688 if (high == (low + length)) { in acpi_res_set_iorange()
693 if (acpi_res_ignore(dev, SYS_RES_IOPORT, low, length)) in acpi_res_set_iorange()
695 bus_set_resource(dev, SYS_RES_IOPORT, cp->ar_nio++, low, length); in acpi_res_set_iorange()
716 acpi_res_set_memoryrange(device_t dev, void *context, uint64_t low, in acpi_res_set_memoryrange() argument
|
| /freebsd/crypto/openssl/crypto/bn/asm/ |
| H A D | x86_64-gcc.c | 75 register BN_ULONG high,low; \
77 : "=a"(low),"=d"(high) \
82 : "a"(low),"g"(0) \
92 register BN_ULONG high,low; \
94 : "=a"(low),"=d"(high) \
99 : "a"(low),"g"(0) \
|
| /freebsd/sys/fs/cd9660/ |
| H A D | cd9660_rrip.c | 388 u_int high, low; in cd9660_rrip_device() local
391 low = isonum_733(p->dev_t_low); in cd9660_rrip_device()
394 ana->inop->inode.iso_rdev = makedev(major(low), minor(low)); in cd9660_rrip_device()
396 ana->inop->inode.iso_rdev = makedev(high, minor(low)); in cd9660_rrip_device()
|
| /freebsd/sys/contrib/device-tree/src/arm64/xilinx/ |
| H A D | zynqmp-sck-kv-g-revB.dts | 208 low-power-disable;
214 low-power-disable;
221 low-power-enable;
|
| H A D | zynqmp-sck-kv-g-revB.dtso | 216 low-power-disable;
222 low-power-disable;
229 low-power-enable;
|
| /freebsd/crypto/openssl/doc/man7/ |
| H A D | evp.pod | 76 Although low-level algorithm specific functions exist for many algorithms
78 versions of new algorithms cannot be accessed using the low-level functions.
80 cleanly supported at the low-level and some operations are more efficient
|
| /freebsd/sys/contrib/device-tree/src/arm/aspeed/ |
| H A D | aspeed-bmc-opp-palmetto.dts | 215 output-low;
222 output-low;
229 output-low;
|
| H A D | aspeed-bmc-opp-romulus.dts | 269 output-low;
274 output-low;
279 output-low;
|
| /freebsd/sys/contrib/device-tree/src/arm/rockchip/ |
| H A D | rk3288-firefly-reload-core.dtsi | 59 snps,reset-active-low;
216 pcfg_output_low: pcfg-output-low {
217 output-low;
|
| /freebsd/sys/contrib/openzfs/module/os/linux/spl/ |
| H A D | spl-xdr.c | 353 uint32_t low, high; in xdrmem_dec_ulonglong() local
359 if (!xdrmem_dec_uint32(xdrs, &low)) in xdrmem_dec_ulonglong()
362 *ullp = ((u_longlong_t)high << 32) | low; in xdrmem_dec_ulonglong()
|
| /freebsd/sys/contrib/device-tree/Bindings/power/reset/ |
| H A D | gpio-poweroff.txt | 20 - gpios : The GPIO to set high/low, see "gpios property" in
22 low to power down the board set it to "Active Low", otherwise set
|