/freebsd/sys/contrib/device-tree/Bindings/mfd/ |
H A D | x-powers,axp152.yaml | 152 DCDC1 power supply node, if present. 156 DCDC2 power supply node, if present. 160 DCDC3 power supply node, if present. 164 DCDC4 power supply node, if present. 168 DCDC5 power supply node, if present. 172 DCDC6 power supply node, if present. 176 DCDC7 power supply node, if present. 200 LDO1 power supply node, if present. 208 LDO3 power supply node, if present. 212 LDO5 power supply node, if present. [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/sound/ |
H A D | st,sta350.txt | 40 If present, thermal warning recovery is enabled. 43 If present, thermal warning adjustment is enabled. 46 If present, then fault recovery will be enabled. 64 If present, overcurrent warning adjustment is enabled. 67 If present, then MPCC bits are used for MPC coefficients, 71 If present, power bridge correction for THD reduction near maximum 75 If present, FFX mode runs in AM reduction mode, otherwise normal 84 If not present, preset DC coefficient is used. 87 If present, automatic invalid input detect mute is enabled. 94 If present, the bridge will be switched off immediately after the [all …]
|
H A D | st,sta32x.txt | 44 If present, thermal warning recovery is enabled. 47 If present, fault detect recovery is enabled. 50 If present, thermal warning adjustment is enabled. 53 If present, then fault recovery will be enabled. 63 If present, then MPCC bits are used for MPC coefficients, 67 If present, power bridge correction for THD reduction near maximum 71 If present, FFX mode runs in AM reduction mode, otherwise normal 75 If present, PWM speed mode run on odd speed mode (341.3 kHz) on all 76 channels. If not present, normal PWM spped mode (384 kHz) will be used. 79 If present, automatic invalid input detect mute is enabled.
|
H A D | wm8994.txt | 46 over 0xffff then the register will be left as default. If present 11 55 - wlf,lineout1-se : If present LINEOUT1 is in single ended mode. 56 - wlf,lineout2-se : If present LINEOUT2 is in single ended mode. 58 - wlf,lineout1-feedback : If present LINEOUT1 has common mode feedback 60 - wlf,lineout2-feedback : If present LINEOUT2 has common mode feedback 63 - wlf,ldoena-always-driven : If present LDOENA is always driven. 65 - wlf,spkmode-pu : If present enable the internal pull-up resistor on 68 - wlf,csnaddr-pd : If present enable the internal pull-down resistor on
|
H A D | cs42l52.txt | 21 - cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured 22 as a differential input. If not present then the MICA input is configured as 25 - cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured 26 as a differential input. If not present then the MICB input is configured as
|
/freebsd/lib/libc/tests/stdlib/ |
H A D | tsearch_test.c | 92 bool present[NKEYS] = {}; in ATF_TC_BODY() local 106 if (present[key]) { in ATF_TC_BODY() 108 present[key] = false; in ATF_TC_BODY() 117 if (present[key]) { in ATF_TC_BODY() 125 if (present[key]) { in ATF_TC_BODY() 131 present[key] = true; in ATF_TC_BODY() 145 if (present[key]) in ATF_TC_BODY()
|
/freebsd/release/scripts/ |
H A D | vagrant.vmx | 13 ethernet0.present = "TRUE" 16 floppy0.present = "FALSE" 24 scsi0.present = "TRUE" 27 scsi0:0.present = "TRUE" 29 usb.present = "FALSE"
|
/freebsd/crypto/openssl/doc/man3/ |
H A D | OCSP_request_add1_nonce.pod | 27 OCSP_copy_nonce() copies any nonce value present in B<req> to B<resp>. 35 was present in B<req> and 0 if an error occurred. 39 nonces are present and equal 1 is returned. If the nonces are absent 2 is 40 returned. If a nonce is present in the response only 3 is returned. If nonces 41 are present and unequal 0 is returned. If the nonce is present in the request 59 positive return value effectively indicates success: nonces are both present 60 and match, both absent or present in the response only. A nonzero return 61 additionally covers the case where the nonce is present in the request only: 63 indicates present and mismatched nonces: this should be treated as an error
|
/freebsd/sys/contrib/device-tree/Bindings/iio/addac/ |
H A D | adi,ad74115.yaml | 142 When present, the digital input range is from 0 to 7400uA in steps 154 When not present, a counter increments when the signal is asserted 176 When present, the threshold range is fixed from -19V to 30V. 181 When not present, the DAC operates in the 0V to 12V range. 182 When present, the DAC operates in the -12V to 12V range. 195 When not present, the DAC short-circuit current limit is 32mA in 197 When present, the limit is 16mA in either source or sink for VOUT, 204 When present, the ADC should be used for measuring 4-wire RTDs. 229 When present, the burnout current polarity for EXT1 is sourcing. 244 When present, the burnout current polarity for EXT2 is sourcing. [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/net/nfc/ |
H A D | st,st-nci.yaml | 22 ese-present: 33 uicc-present: 79 ese-present; 80 uicc-present; 102 ese-present; 103 uicc-present;
|
H A D | st21nfca.txt | 12 - ese-present: Specifies that an ese is physically connected to the nfc 14 - uicc-present: Specifies that the uicc swp signal can be physically 34 ese-present; 35 uicc-present;
|
H A D | st-nci-spi.txt | 12 - ese-present: Specifies that an ese is physically connected to the nfc 14 - uicc-present: Specifies that the uicc swp signal can be physically 33 ese-present; 34 uicc-present;
|
H A D | st-nci-i2c.txt | 13 - ese-present: Specifies that an ese is physically connected to the nfc 15 - uicc-present: Specifies that the uicc swp signal can be physically 35 ese-present; 36 uicc-present;
|
H A D | st,st21nfca.yaml | 19 ese-present: 30 uicc-present: 61 ese-present; 62 uicc-present;
|
/freebsd/sys/contrib/device-tree/Bindings/media/ |
H A D | coda.txt | 4 Coda codec IPs are present in i.MX SoCs in various versions, 9 (a) "fsl,imx27-vpu" for CodaDx6 present in i.MX27 10 (b) "fsl,imx51-vpu" for CodaHx4 present in i.MX51 11 (c) "fsl,imx53-vpu" for CODA7541 present in i.MX53 12 (d) "fsl,imx6q-vpu" for CODA960 present in i.MX6q
|
/freebsd/lib/libc/amd64/string/ |
H A D | strchrnul.S | 135 pcmpeqb %xmm1, %xmm2 # NUL bytes present? 137 pcmpeqb %xmm0, %xmm1 # c present? 138 por %xmm2, %xmm1 # either present? 147 pcmpeqb %xmm1, %xmm2 # NUL bytes present? 148 pcmpeqb %xmm0, %xmm1 # c present? 149 por %xmm2, %xmm1 # either present? 157 pcmpeqb %xmm1, %xmm2 # NUL bytes present? 158 pcmpeqb %xmm0, %xmm1 # c present? 159 por %xmm2, %xmm1 # either present?
|
/freebsd/lib/libgssapi/ |
H A D | gss_test_oid_set_member.c | 37 int *present) in gss_test_oid_set_member() argument 41 *present = 0; in gss_test_oid_set_member() 44 *present = 1; in gss_test_oid_set_member()
|
H A D | gss_inquire_mechs_for_name.c | 43 int present; in gss_inquire_mechs_for_name() local 66 &name->gn_type, name_types, &present); in gss_inquire_mechs_for_name() 68 if (present) { in gss_inquire_mechs_for_name()
|
/freebsd/sys/kgssapi/ |
H A D | gss_test_oid_set_member.c | 42 int *present) in gss_test_oid_set_member() argument 46 *present = 0; in gss_test_oid_set_member() 49 *present = 1; in gss_test_oid_set_member()
|
/freebsd/crypto/heimdal/lib/gssapi/mech/ |
H A D | gss_test_oid_set_member.c | 35 int *present) in gss_test_oid_set_member() argument 39 *present = 0; in gss_test_oid_set_member() 42 *present = 1; in gss_test_oid_set_member()
|
H A D | gss_add_oid_set_member.c | 62 int present; in gss_add_oid_set_member() local 64 res = gss_test_oid_set_member(minor_status, member_oid, *oid_set, &present); in gss_add_oid_set_member() 68 if (present) { in gss_add_oid_set_member()
|
H A D | gss_inquire_mechs_for_name.c | 40 int present; in gss_inquire_mechs_for_name() local 63 &name->gn_type, name_types, &present); in gss_inquire_mechs_for_name() 65 if (present) { in gss_inquire_mechs_for_name()
|
/freebsd/sys/compat/linuxkpi/common/src/ |
H A D | linux_acpi.c | 191 bool present = false; in acpi_dev_present_cb() local 207 present = true; in acpi_dev_present_cb() 212 present = true; in acpi_dev_present_cb() 217 if (present && match->uid != NULL && in acpi_dev_present_cb() 220 present = false; in acpi_dev_present_cb() 223 if (!present) in acpi_dev_present_cb()
|
/freebsd/sys/contrib/device-tree/Bindings/slimbus/ |
H A D | bus.txt | 15 If child node is not present and it is instantiated after device 16 discovery (slave device reporting itself present). 20 such cases, child nodes for those devices will be present as 23 Required property for SLIMbus child node if it is present: 35 Optional property for SLIMbus child node if it is present:
|
/freebsd/crypto/openssl/doc/man1/ |
H A D | openssl-dhparam.pod.in | 57 if this option is not present. The output filename should B<not> be the same 79 The generator to use, either 2, 3 or 5. If present then the 81 present but I<numbits> is present, parameters are generated with the 87 I<numbits>. It must be the last option. If this option is present then 89 this option is not present but a generator (B<-2>, B<-3> or B<-5>) is 90 present, parameters are generated with a default length of 2048 bits.
|