1 /* $NetBSD: sireg.h,v 1.3 2008/04/28 20:24:01 martin Exp $ */ 2 3 /*- 4 * Copyright (c) 2000 The NetBSD Foundation, Inc. 5 * All rights reserved. 6 * 7 * This code is derived from software contributed to The NetBSD Foundation 8 * by Paul Kranenburg. 9 * 10 * Redistribution and use in source and binary forms, with or without 11 * modification, are permitted provided that the following conditions 12 * are met: 13 * 1. Redistributions of source code must retain the above copyright 14 * notice, this list of conditions and the following disclaimer. 15 * 2. Redistributions in binary form must reproduce the above copyright 16 * notice, this list of conditions and the following disclaimer in the 17 * documentation and/or other materials provided with the distribution. 18 * 19 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 20 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 21 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 22 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 23 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 24 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 25 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 26 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 27 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 28 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 29 * POSSIBILITY OF SUCH DAMAGE. 30 */ 31 32 /* 33 * Register map for the VME SCSI-3 adpater (si) 34 * The first part of this register map is an NCR5380 35 * SCSI Bus Interface Controller (SBIC). The rest is a 36 * DMA controller and custom logic. 37 */ 38 39 40 #if __for_reference_only__ 41 /* 42 * Am5380 Register map (no padding). See dev/ic/ncr5380reg.h 43 */ 44 struct ncr5380regs { 45 u_char r[8]; 46 }; 47 48 struct si_regs { 49 struct ncr5380regs sci; 50 51 /* DMA controller registers */ 52 u_short dma_addrh; /* DMA address (VME only) */ 53 u_short dma_addrl; /* (high word, low word) */ 54 u_short dma_counth; /* DMA count (VME only) */ 55 u_short dma_countl; /* (high word, low word) */ 56 57 u_int pad0; /* no-existent register */ 58 59 u_short fifo_data; /* fifo data register */ 60 u_short fifo_count; /* fifo count register */ 61 u_short si_csr; /* si control/status */ 62 u_short bprh; /* VME byte pack high */ 63 u_short bprl; /* VME byte pack low */ 64 u_short iv_am; /* bits 0-7: intr vector */ 65 /* bits 8-13: addr modifier (VME only) */ 66 /* bits 14-15: unused */ 67 u_short fifo_cnt_hi; /* high part of fifo_count (VME only) */ 68 69 /* Whole thing repeats after 32 bytes. */ 70 u_short _space[3]; 71 }; 72 #endif 73 74 /* 75 * Size of NCR5380 registers located at the bottom of the register bank 76 */ 77 #define NCR5380REGS_SZ 8 78 79 /* 80 * Register definition for the `si' VME controller 81 */ 82 #define SIREG_DMA_ADDRH (NCR5380REGS_SZ + 0) /* DMA address, high word */ 83 #define SIREG_DMA_ADDRL (NCR5380REGS_SZ + 2) /* DMA address, low word */ 84 #define SIREG_DMA_CNTH (NCR5380REGS_SZ + 4) /* DMA count, high word */ 85 #define SIREG_DMA_CNTL (NCR5380REGS_SZ + 6) /* DMA count, low word */ 86 #define SIREG_FIFO_DATA (NCR5380REGS_SZ + 12) /* FIFO data */ 87 #define SIREG_FIFO_CNT (NCR5380REGS_SZ + 14) /* FIFO count, low word */ 88 #define SIREG_CSR (NCR5380REGS_SZ + 16) /* Control/status register */ 89 #define SIREG_BPRH (NCR5380REGS_SZ + 18) /* VME byte pack, high word */ 90 #define SIREG_BPRL (NCR5380REGS_SZ + 20) /* VME byte pack, low word */ 91 #define SIREG_IV_AM (NCR5380REGS_SZ + 22) /* bits 0-7: intr vector; 92 bits 8-13: addr modifier */ 93 #define SIREG_FIFO_CNTH (NCR5380REGS_SZ + 24) /* FIFO count, high word */ 94 #define SIREG_BANK_SZ (NCR5380REGS_SZ + 26) 95 96 /* 97 * Status Register. 98 * Note: 99 * (r) indicates bit is read only. 100 * (rw) indicates bit is read or write. 101 * (v) vme host adaptor interface only. 102 * (o) sun3/50 onboard host adaptor interface only. 103 * (b) both vme and sun3/50 host adaptor interfaces. 104 * 105 * Note 2: because of the historical connections of this VME driver 106 * with the on-board SCSI interfaces found in sun3/50, sun3/60 and sun4/100 107 * systems, the (v), (o) and (b) qualifications are left in for 108 * cross-reference. 109 */ 110 #define SI_CSR_DMA_ACTIVE 0x8000 /* (r,o) DMA transfer active */ 111 #define SI_CSR_DMA_CONFLICT 0x4000 /* (r,b) reg accessed while DMA'ing */ 112 #define SI_CSR_DMA_BUS_ERR 0x2000 /* (r,b) bus error during DMA */ 113 #define SI_CSR_ID 0x1000 /* (r,b) 0 for 3/50, 1 for SCSI-3, */ 114 /* 0 if SCSI-3 unmodified */ 115 #define SI_CSR_FIFO_FULL 0x0800 /* (r,b) fifo full */ 116 #define SI_CSR_FIFO_EMPTY 0x0400 /* (r,b) fifo empty */ 117 #define SI_CSR_SBC_IP 0x0200 /* (r,b) sbc interrupt pending */ 118 #define SI_CSR_DMA_IP 0x0100 /* (r,b) DMA interrupt pending */ 119 #define SI_CSR_LOB 0x00c0 /* (r,v) number of leftover bytes */ 120 #define SI_CSR_LOB_THREE 0x00c0 /* (r,v) three leftover bytes */ 121 #define SI_CSR_LOB_TWO 0x0080 /* (r,v) two leftover bytes */ 122 #define SI_CSR_LOB_ONE 0x0040 /* (r,v) one leftover byte */ 123 #define SI_CSR_BPCON 0x0020 /* (rw,v) byte packing control */ 124 /* DMA is in 0=longwords, 1=words */ 125 #define SI_CSR_DMA_EN 0x0010 /* (rw,v) DMA/interrupt enable */ 126 #define SI_CSR_SEND 0x0008 /* (rw,b) DMA dir, 1=to device */ 127 #define SI_CSR_INTR_EN 0x0004 /* (rw,b) interrupts enable */ 128 #define SI_CSR_FIFO_RES 0x0002 /* (rw,b) inits fifo, 0=reset */ 129 #define SI_CSR_SCSI_RES 0x0001 /* (rw,b) reset sbc and udc, 0=reset */ 130