1 /* $NetBSD: lxtphyreg.h,v 1.2 2008/04/28 20:23:53 martin Exp $ */ 2 3 /*- 4 * Copyright (c) 1998 The NetBSD Foundation, Inc. 5 * All rights reserved. 6 * 7 * This code is derived from software contributed to The NetBSD Foundation 8 * by Jason R. Thorpe of the Numerical Aerospace Simulation Facility, 9 * NASA Ames Research Center. 10 * 11 * Redistribution and use in source and binary forms, with or without 12 * modification, are permitted provided that the following conditions 13 * are met: 14 * 1. Redistributions of source code must retain the above copyright 15 * notice, this list of conditions and the following disclaimer. 16 * 2. Redistributions in binary form must reproduce the above copyright 17 * notice, this list of conditions and the following disclaimer in the 18 * documentation and/or other materials provided with the distribution. 19 * 20 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 21 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 22 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 23 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 24 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 25 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 26 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 27 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 28 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 29 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 30 * POSSIBILITY OF SUCH DAMAGE. 31 */ 32 33 #ifndef _DEV_MII_LXTPHYREG_H_ 34 #define _DEV_MII_LXTPHYREG_H_ 35 36 /* 37 * LXT970 registers. 38 */ 39 40 #define MII_LXTPHY_MIRROR 0x10 /* Mirror register */ 41 /* All bits user-defined */ 42 43 #define MII_LXTPHY_IER 0x11 /* Interrupt Enable Register */ 44 #define IER_MIIDRVLVL 0x0008 /* Rediced MII driver levels */ 45 #define IER_LNK_CRITERIA 0x0004 /* Enhanced Link Loss Criteria */ 46 #define IER_INTEN 0x0002 /* Interrupt Enable */ 47 #define IER_TINT 0x0001 /* Force Interrupt */ 48 49 #define MII_LXTPHY_ISR 0x12 /* Interrupt Status Register */ 50 #define ISR_MINT 0x8000 /* MII Interrupt Pending */ 51 #define ISR_XTALOK 0x4000 /* Clocks OK */ 52 53 #define MII_LXTPHY_CONFIG 0x13 /* Configuration Register */ 54 #define CONFIG_TXMIT_TEST 0x4000 /* 100base-T Transmit Test */ 55 #define CONFIG_REPEATER 0x2000 /* Repeater Mode */ 56 #define CONFIG_MDIO_INT 0x1000 /* Enable intr signalling on MDIO */ 57 #define CONFIG_TPLOOP 0x0800 /* Disable 10base-T Loopback */ 58 #define CONFIG_SQE 0x0400 /* Enable SQE */ 59 #define CONFIG_DISJABBER 0x0200 /* Disable Jabber */ 60 #define CONFIG_DISLINKTEST 0x0100 /* Disable Link Test */ 61 #define CONFIG_LEDC1 0x0080 /* LEDC configuration */ 62 #define CONFIG_LEDC0 0x0040 /* ... */ 63 /* 0 0 LEDC indicates collision */ 64 /* 0 1 LEDC is off */ 65 /* 1 0 LEDC indicates activity */ 66 /* 1 1 LEDC is on */ 67 #define CONFIG_ADVTXCLK 0x0020 /* Advance TX clock */ 68 #define CONFIG_5BSYMBOL 0x0010 /* 5-bit Symbol mode */ 69 #define CONFIG_SCRAMBLER 0x0008 /* Bypass scrambler */ 70 #define CONFIG_100BASEFX 0x0004 /* 100base-FX */ 71 #define CONFIG_TXDISCON 0x0001 /* Disconnect TP transmitter */ 72 73 #define MII_LXTPHY_CSR 0x14 /* Chip Status Register */ 74 #define CSR_LINK 0x2000 /* Link is up */ 75 #define CSR_DUPLEX 0x1000 /* Full-duplex */ 76 #define CSR_SPEED 0x0800 /* 100Mbps */ 77 #define CSR_ACOMP 0x0400 /* Autonegotiation complete */ 78 #define CSR_PAGERCVD 0x0200 /* Link page received */ 79 #define CSR_LOWVCC 0x0004 /* Low Voltage Fault */ 80 81 #endif /* _DEV_MII_LXTPHYREG_H_ */ 82