Home
last modified time | relevance | path

Searched refs:RGB (Results 1 – 25 of 174) sorted by relevance

1234567

/linux/drivers/leds/
H A DTODO29 really different from driver for RGB color LED that can run its own
32 * Figure out what to do with RGB leds
36 RGB, and not even RGB-White or RGB-Yellow variants emerged.
38 Multicolor is not a good fit for RGB LED. It does not really know
46 multicolor for RGB LEDs.
50 RGB LEDs are quite common, and it would be good to be able to turn LED
/linux/Documentation/leds/
H A Dleds-mt6370-rgb.rst4 The device for Mediatek MT6370 RGB LED
10 The MT6370 integrates a four-channel RGB LED driver, designed to provide a
11 variety of lighting effect for mobile device applications. The RGB LED devices
14 current up to 6mA. It provides three operation modes for RGB LEDs:
16 can increase or decrease the brightness of the RGB LED via an I2C interface.
24 Specify a hardware breath pattern for a MT6370 RGB LED.
H A Dleds-lp5562.rst26 Value: RGB or W
46 Engine mux has two different mode, RGB and W.
47 RGB is used for loading RGB program data, W is used for W program data.
52 echo "RGB" > /sys/bus/i2c/devices/xxxx/engine_mux # engine mux for RGB
H A Dleds-qcom-lpg.rst11 number of PWM channels, a programmable pattern lookup table and a RGB LED
15 individual LEDs, grouped together as RGB LEDs or otherwise be accessed as PWM
17 blocks, such as the RGB current sink, GPIO pins etc.
/linux/Documentation/devicetree/bindings/leds/
H A Dcznic,turris-omnia-leds.yaml13 This module adds support for the RGB LEDs found on the front panel of the
14 Turris Omnia router. There are 12 RGB LEDs that are controlled by a
39 This node represents one of the RGB LED devices on Turris Omnia.
41 supports RGB LEDs.
73 * No subnodes are needed, this controller only supports RGB
H A Dleds-lp50xx.yaml7 title: LED driver for LP50XX RGB LED from Texas Instruments.
13 The LP50XX is multi-channel, I2C RGB LED Drivers that can group RGB LEDs into
16 The difference in these RGB LED drivers is the number of supported RGB
H A Dkinetic,ktd202x.yaml7 title: Kinetic KTD2026/7 RGB/White LED Driver
13 The KTD2026/7 is a RGB/White LED driver with I2C interface.
/linux/Documentation/fb/
H A Darkfb.rst21 * 16 bpp truecolor modes (RGB 555 and RGB 565)
22 * 24 bpp truecolor mode (RGB 888)
23 * 32 bpp truecolor mode (RGB 888)
H A Ds3fb.rst28 * 16 bpp truecolor modes (RGB 555 and RGB 565)
29 * 24 bpp truecolor mode (RGB 888) on (only on Virge VX)
30 * 32 bpp truecolor mode (RGB 888) on (not on Virge VX)
H A Dvt8623fb.rst20 * 16 bpp truecolor mode (RGB 565)
21 * 32 bpp truecolor mode (RGB 888)
H A Dpxafb.rst89 support palette and no-palette RGB formats, as well as YUV formats (only
144 4) var->{red, green, blue, transp} if RGB mode is to be used
165 - 0 - RGB
/linux/Documentation/userspace-api/media/v4l/
H A Dmetafmt-vsp1-hgo.rst18 The VSP1 HGO is a histogram computation engine that can operate on RGB, YCrCb
24 three channels (RGB data only) or on the Y channel only (YCbCr only). It can
29 to compute three 64-bins histograms. RGB, YCbCr and HSV image formats are
32 channels to compute a single 64-bins histogram. Only the RGB image format is
37 channels to compute a single 256-bins histogram. Only the RGB image format is
H A Dpixfmt-rgb.rst6 RGB Formats
9 These formats encode each pixel as a triplet of RGB values. They are packed
10 formats, meaning that the RGB values for one pixel are stored consecutively in
15 The formats differ by the number of bits per RGB component (typically but not
75 .. flat-table:: RGB Formats With Less Than 8 Bits Per Component
660 .. flat-table:: RGB Formats With 8 Bits Per Component
784 .. flat-table:: RGB Formats 10 Bits Per Color Component
967 .. flat-table:: RGB Formats With 12 Bits Per Component
1013 .. flat-table:: RGB Formats With 16 Bits Per Component
1053 Deprecated RGB Formats
[all …]
H A Dcolorspaces.rst13 actually *means* to have an RGB value of e.g. (255, 0, 0). That is,
23 different wavelengths, so instead of RGB we would be using the
91 Both the CIE XYZ and the RGB colorspace that are derived from the
99 values are denoted RGB, non-linear are denoted as R'G'B'. In general
101 linear RGB. Special care should be taken when dealing with openGL to
102 provide linear RGB colors or to use the built-in openGL support to apply
121 The final step is how the RGB, R'G'B' or Y'CbCr values are quantized.
130 definition. In practice RGB or R'G'B' values are full range, i.e. they
134 Unfortunately, in some cases limited range RGB is also used where the
/linux/drivers/gpu/drm/panel/
H A DKconfig361 tristate "LG LB035Q024573 RGB panel"
369 tristate "LG4573 RGB/SPI panel"
412 tristate "NEC NL8048HL11 RGB panel"
429 tristate "NewVision NV3052C RGB/SPI panel"
438 tristate "Novatek NT35510 RGB panel driver"
498 RGB per pixel.
501 tristate "Novatek NT39016 RGB/SPI panel"
647 tristate "Samsung LD9040 RGB/SPI panel"
700 tristate "Samsung S6E63M0 RGB panel"
709 tristate "Samsung S6E63M0 RGB SPI interface"
[all …]
/linux/Documentation/devicetree/bindings/display/bridge/
H A Dtoshiba,tc358768.yaml7 title: Toschiba TC358768/TC358778 Parallel RGB to MIPI DSI bridge
13 The TC358768/TC358778 is bridge device which converts RGB to DSI.
52 Video port for RGB input
H A Dchipone,icn6211.yaml7 title: Chipone ICN6211 MIPI-DSI to RGB Converter bridge
13 ICN6211 is MIPI-DSI to RGB Converter bridge from chipone.
46 description: A 1.8V/2.5V/3.3V supply that power the RGB output.
/linux/drivers/leds/rgb/
H A DKconfig23 RGB/White LED driver found in different BQ mobile phones.
35 Triple Output I2C Controlled RGB LED Driver.
60 sink, intended to drive RGB LEDs. Each channel can either be used as
61 a LED, grouped to represent a RGB LED or exposed as PWM channels.
/linux/Documentation/gpu/
H A Dafbc.rst28 (AFBC_FORMAT_MOD_YTR, which should be enabled for RGB buffers for
126 - 10-bit per component RGB, with 2-bit alpha
134 - 8-bit per component RGB, with 8-bit alpha
142 - 8-bit per component RGB
149 - 5/6-bit per component RGB
156 - 5-bit per component RGB, with 1-bit alpha
/linux/Documentation/devicetree/bindings/display/
H A Datmel,lcdc-display.yaml59 description: lcd wiring mode "RGB" or "BRG"
61 - RGB
87 atmel,lcd-wiring-mode = "RGB";
/linux/arch/arm/boot/dts/ti/omap/
H A Dam335x-boneblack-hdmi.dtsi56 /* If you want to get 24 bit RGB and 16 BGR mode instead of
57 * current 16 bit RGB and 24 BGR modes, set the propety
81 /* Convert 24bit BGR to RGB, e.g. cross red and blue wiring */
/linux/Documentation/admin-guide/media/
H A Dvimc.dot21 …n00000013 [label="{{} | RGB/YUV Input\n/dev/v4l-subdev4 | {<port0> 0}}", shape=Mrecord, style=fill…
25 n00000018 [label="RGB/YUV Capture\n/dev/video2", shape=box, style=filled, fillcolor=yellow]
/linux/drivers/gpu/drm/rockchip/
H A DKconfig98 bool "Rockchip RGB support"
104 Choose this option to enable support for Rockchip RGB output.
106 and serial RGB format to panel or connect to a conversion chip.
/linux/Documentation/devicetree/bindings/display/panel/
H A Dtpo,tpg110.yaml15 between an RGB output and a variety of panels. The panel
24 RGB -> | TPG110 |
/linux/drivers/gpu/drm/bridge/imx/
H A Dimx8qxp-pixel-combiner.c55 RGB, enumerator
166 val |= PC_DISP0_PIX_DATA_FORMAT(RGB); in imx8qxp_pc_bridge_mode_set()
169 val |= PC_DISP1_PIX_DATA_FORMAT(RGB); in imx8qxp_pc_bridge_mode_set()

1234567