1 /* $OpenBSD: lsi64854reg.h,v 1.4 2008/06/26 05:42:15 ray Exp $ */ 2 /* $NetBSD: lsi64854reg.h,v 1.5 2001/03/29 02:58:39 petrov Exp $ */ 3 4 /*- 5 * Copyright (c) 1998 The NetBSD Foundation, Inc. 6 * All rights reserved. 7 * 8 * This code is derived from software contributed to The NetBSD Foundation 9 * by Paul Kranenburg. 10 * 11 * Redistribution and use in source and binary forms, with or without 12 * modification, are permitted provided that the following conditions 13 * are met: 14 * 1. Redistributions of source code must retain the above copyright 15 * notice, this list of conditions and the following disclaimer. 16 * 2. Redistributions in binary form must reproduce the above copyright 17 * notice, this list of conditions and the following disclaimer in the 18 * documentation and/or other materials provided with the distribution. 19 * 20 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 21 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 22 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 23 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 24 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 25 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 26 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 27 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 28 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 29 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 30 * POSSIBILITY OF SUCH DAMAGE. 31 */ 32 33 /* 34 * LSI 64854 DMA engine. Contains three independent channels 35 * designed to interface with (a) a NCR539X SCSI controller, 36 * (b) a AM7990 Ethernet controller, (c) Parallel port hardware.. 37 */ 38 39 /* 40 * Register offsets to bus handle. 41 */ 42 #define L64854_REG_CSR 0 /* Control bits */ 43 #define L64854_REG_ADDR 4 /* DMA Address */ 44 #define L64854_REG_CNT 8 /* DMA count */ 45 #define L64854_REG_CNT_MASK 0x00ffffff /* only 24 bits */ 46 #define L64854_REG_ENBAR 12 /* ENET Base register */ 47 #define L64854_REG_TEST 12 /* SCSI Test register */ 48 #define L64854_REG_HCR 16 /* PP Hardware Configuration */ 49 #define L64854_REG_OCR 18 /* PP Operation Configuration */ 50 #define L64854_REG_DR 20 /* PP Data register */ 51 #define L64854_REG_TCR 21 /* PP Transfer Control */ 52 #define L64854_REG_OR 22 /* PP Output register */ 53 #define L64854_REG_IR 23 /* PP Input register */ 54 #define L64854_REG_ICR 24 /* PP Interrupt Control */ 55 56 57 /* 58 * Control bits common to all three channels. 59 */ 60 #define L64854_INT_PEND 0x00000001 /* Interrupt pending */ 61 #define L64854_ERR_PEND 0x00000002 /* Error pending */ 62 #define L64854_DRAINING 0x0000000c /* FIFO draining */ 63 #define L64854_INT_EN 0x00000010 /* Interrupt enable */ 64 #define L64854_INVALIDATE 0x00000020 /* Invalidate FIFO */ 65 #define L64854_SLAVE_ERR 0x00000040 /* Slave access size error */ 66 #define L64854_RESET 0x00000080 /* Reset device */ 67 #define L64854_WRITE 0x00000100 /* 1: xfer to memory */ 68 #define L64854_EN_DMA 0x00000200 /* enable DMA transfers */ 69 70 #define L64854_BURST_SIZE 0x000c0000 /* Read/write burst size */ 71 #define L64854_BURST_0 0x00080000 /* no bursts (SCSI-only) */ 72 #define L64854_BURST_16 0x00000000 /* 16-byte bursts */ 73 #define L64854_BURST_32 0x00040000 /* 32-byte bursts */ 74 #define L64854_BURST_64 0x000c0000 /* 64-byte bursts (fas) */ 75 76 #define L64854_RST_FAS366 0x08000000 /* FAS366 hardware reset */ 77 78 #define L64854_DEVID 0xf0000000 /* device ID bits */ 79 80 /* 81 * SCSI DMA control bits. 82 */ 83 #define D_INT_PEND L64854_INT_PEND /* interrupt pending */ 84 #define D_ERR_PEND L64854_ERR_PEND /* error pending */ 85 #define D_DRAINING L64854_DRAINING /* fifo draining */ 86 #define D_INT_EN L64854_INT_EN /* interrupt enable */ 87 #define D_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 88 #define D_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 89 #define D_RESET L64854_RESET /* reset scsi */ 90 #define D_WRITE L64854_WRITE /* 1 = dev -> mem */ 91 #define D_EN_DMA L64854_EN_DMA /* enable DMA requests */ 92 #define D_EN_CNT 0x00002000 /* enable byte counter */ 93 #define D_TC 0x00004000 /* terminal count */ 94 #define D_WIDE_EN 0x00008000 /* enable wide mode SBUS DMA (fas) */ 95 #define D_DSBL_CSR_DRN 0x00010000 /* disable fifo drain on csr */ 96 #define D_DSBL_SCSI_DRN 0x00020000 /* disable fifo drain on reg */ 97 98 #define D_DIAG 0x00100000 /* disable fifo drain on addr */ 99 #define D_TWO_CYCLE 0x00200000 /* 2 clocks per transfer */ 100 #define D_FASTER 0x00400000 /* 3 clocks per transfer */ 101 #define D_TCI_DIS 0x00800000 /* disable intr on D_TC */ 102 #define D_EN_NEXT 0x01000000 /* enable auto next address */ 103 #define D_DMA_ON 0x02000000 /* enable dma from scsi XXX */ 104 #define D_DSBL_PARITY_CHK \ 105 0x02000000 /* disable checking for parity on bus (default 1:fas) */ 106 #define D_A_LOADED 0x04000000 /* address loaded */ 107 #define D_NA_LOADED 0x08000000 /* next address loaded */ 108 #define D_HW_RESET_FAS366 \ 109 0x08000000 /* hardware reset FAS366 (fas) */ 110 #define D_DEV_ID L64854_DEVID /* device ID */ 111 #define DMAREV_0 0x00000000 /* Sunray DMA */ 112 #define DMAREV_ESC 0x40000000 /* DMA ESC array */ 113 #define DMAREV_1 0x80000000 /* 'DMA' */ 114 #define DMAREV_PLUS 0x90000000 /* 'DMA+' */ 115 #define DMAREV_2 0xa0000000 /* 'DMA2' */ 116 #define DMAREV_HME 0xb0000000 /* 'HME' */ 117 118 /* 119 * revisions 0,1 and ESC have different bits. 120 */ 121 #define D_ESC_DRAIN 0x00000040 /* rev0,1,esc: drain fifo */ 122 #define D_ESC_R_PEND 0x00000400 /* rev0,1: request pending */ 123 #define D_ESC_BURST 0x00000800 /* DMA ESC: 16 byte bursts */ 124 #define D_ESC_AUTODRAIN 0x00040000 /* DMA ESC: Auto-drain */ 125 126 #define DDMACSR_BITS "\020" \ 127 "\01INT\02ERR\03DR1\04DR2\05IEN" \ 128 "\07SLVERR\010RST\011WRITE\012ENDMA" \ 129 "\016ENCNT\017TC\021DSBL_CSR_DRN" \ 130 "\022DSBL_SCSI_DRN\026TWOCYCLE" \ 131 "\027FASTER\030TCIDIS\031ENNXT\032DMAON" \ 132 "\033ALOADED\034NALOADED" 133 134 135 /* 136 * ENET DMA control bits. 137 */ 138 #define E_INT_PEND L64854_INT_PEND /* interrupt pending */ 139 #define E_ERR_PEND L64854_ERR_PEND /* error pending */ 140 #define E_DRAINING L64854_DRAINING /* fifo draining */ 141 #define E_INT_EN L64854_INT_EN /* interrupt enable */ 142 #define E_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 143 #define E_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 144 #define E_RESET L64854_RESET /* reset ENET */ 145 #define E_reserved1 0x00000300 /* */ 146 #define E_DRAIN 0x00000400 /* force Ecache drain */ 147 #define E_DSBL_WR_DRN 0x00000800 /* disable Ecache drain on .. */ 148 #define E_DSBL_RD_DRN 0x00001000 /* disable Ecache drain on .. */ 149 #define E_reserved2 0x00006000 /* */ 150 #define E_ILACC 0x00008000 /* ... */ 151 #define E_DSBL_BUF_WR 0x00010000 /* no buffering of slave writes */ 152 #define E_DSBL_WR_INVAL 0x00020000 /* no Ecache invalidate on slave writes */ 153 154 #define E_reserved3 0x00100000 /* */ 155 #define E_LOOP_TEST 0x00200000 /* loopback mode */ 156 #define E_TP_AUI 0x00400000 /* 1 for TP, 0 for AUI */ 157 #define E_reserved4 0x0c800000 /* */ 158 #define E_DEV_ID L64854_DEVID /* ID bits */ 159 160 #define EDMACSR_BITS "\020" \ 161 "\01INT\02ERR\05IEN" \ 162 "\07SLVERR\010RST\011WRITE\013DRAIN" \ 163 "\014DSBL_WR_DRN\015DSBL_RD_DRN\020ILACC" \ 164 "\021DSBL_BUF_WR\022DSBL_WR_INVAL" \ 165 "\026LOOPTEST\027TP" 166 167 /* 168 * PP DMA control bits. 169 */ 170 #define P_INT_PEND L64854_INT_PEND /* interrupt pending */ 171 #define P_ERR_PEND L64854_ERR_PEND /* error pending */ 172 #define P_DRAINING L64854_DRAINING /* fifo draining */ 173 #define P_INT_EN L64854_INT_EN /* interrupt enable */ 174 #define P_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 175 #define P_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 176 #define P_RESET L64854_RESET /* reset PP */ 177 #define P_WRITE L64854_WRITE /* 1: xfer to memory */ 178 #define P_EN_DMA L64854_EN_DMA /* enable DMA transfers */ 179 #define P_reserved1 0x00001c00 /* */ 180 #define P_EN_CNT 0x00002000 /* enable counter */ 181 #define P_TC 0x00004000 /* terminal count */ 182 #define P_reserved2 0x00038000 /* */ 183 184 #define P_DIAG 0x00100000 /* ... */ 185 #define P_reserved3 0x00600000 /* */ 186 #define P_TCI_DIS 0x00800000 /* no interrupt on terminal count */ 187 #define P_EN_NEXT 0x01000000 /* enable DMA chaining */ 188 #define P_DMA_ON 0x02000000 /* DMA xfers enabled */ 189 #define P_A_LOADED 0x04000000 /* addr and byte count valid */ 190 #define P_NA_LOADED 0x08000000 /* next addr & count valid but not used */ 191 #define P_DEV_ID L64854_DEVID /* ID bits */ 192 193 #define PDMACSR_BITS "\020" \ 194 "\01INT\02ERR\05IEN" \ 195 "\07SLVERR\010RST\011WRITE\012ENDMA" \ 196 "\016ENCNT\017TC\025DIAG\030TCIDIS" \ 197 "\031ENNXT\032DMAON\033ALOADED\034NALOADED" 198