1; RUN: opt < %s -sroa -S | FileCheck %s 2; RUN: opt < %s -sroa -force-ssa-updater -S | FileCheck %s 3target datalayout = "e-p:64:64:64-i1:8:8-i8:8:8-i16:16:16-i32:32:32-i64:32:64-f32:32:32-f64:64:64-v64:64:64-v128:128:128-a0:0:64-n8:16:32:64" 4 5define { i32, i32 } @test0(i32 %x, i32 %y) { 6; CHECK-LABEL: @test0( 7; CHECK-NOT: alloca 8; CHECK: insertvalue { i32, i32 } 9; CHECK: insertvalue { i32, i32 } 10; CHECK: ret { i32, i32 } 11 12entry: 13 %a = alloca { i32, i32 } 14 15 store { i32, i32 } undef, { i32, i32 }* %a 16 17 %gep1 = getelementptr inbounds { i32, i32 }* %a, i32 0, i32 0 18 store i32 %x, i32* %gep1 19 %gep2 = getelementptr inbounds { i32, i32 }* %a, i32 0, i32 1 20 store i32 %y, i32* %gep2 21 22 %result = load { i32, i32 }* %a 23 ret { i32, i32 } %result 24} 25 26define { i32, i32 } @test1(i32 %x, i32 %y) { 27; FIXME: This may be too conservative. Duncan argues that we are allowed to 28; split the volatile load and store here but must produce volatile scalar loads 29; and stores from them. 30; CHECK-LABEL: @test1( 31; CHECK: alloca 32; CHECK: alloca 33; CHECK: load volatile { i32, i32 }* 34; CHECK: store volatile { i32, i32 } 35; CHECK: ret { i32, i32 } 36 37entry: 38 %a = alloca { i32, i32 } 39 %b = alloca { i32, i32 } 40 41 %gep1 = getelementptr inbounds { i32, i32 }* %a, i32 0, i32 0 42 store i32 %x, i32* %gep1 43 %gep2 = getelementptr inbounds { i32, i32 }* %a, i32 0, i32 1 44 store i32 %y, i32* %gep2 45 46 %result = load volatile { i32, i32 }* %a 47 store volatile { i32, i32 } %result, { i32, i32 }* %b 48 ret { i32, i32 } %result 49} 50