1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * Copyright (c) 2011-2016 Zhang, Keguang <keguang.zhang@gmail.com>
4 */
5
6 #include <linux/clk.h>
7 #include <linux/dma-mapping.h>
8 #include <linux/err.h>
9 #include <linux/mtd/partitions.h>
10 #include <linux/sizes.h>
11 #include <linux/phy.h>
12 #include <linux/serial_8250.h>
13 #include <linux/stmmac.h>
14 #include <linux/usb/ehci_pdriver.h>
15
16 #include <platform.h>
17 #include <loongson1.h>
18 #include <cpufreq.h>
19 #include <dma.h>
20 #include <nand.h>
21
22 /* 8250/16550 compatible UART */
23 #define LS1X_UART(_id) \
24 { \
25 .mapbase = LS1X_UART ## _id ## _BASE, \
26 .irq = LS1X_UART ## _id ## _IRQ, \
27 .iotype = UPIO_MEM, \
28 .flags = UPF_IOREMAP | UPF_FIXED_TYPE, \
29 .type = PORT_16550A, \
30 }
31
32 static struct plat_serial8250_port ls1x_serial8250_pdata[] = {
33 LS1X_UART(0),
34 LS1X_UART(1),
35 LS1X_UART(2),
36 LS1X_UART(3),
37 {},
38 };
39
40 struct platform_device ls1x_uart_pdev = {
41 .name = "serial8250",
42 .id = PLAT8250_DEV_PLATFORM,
43 .dev = {
44 .platform_data = ls1x_serial8250_pdata,
45 },
46 };
47
ls1x_serial_set_uartclk(struct platform_device * pdev)48 void __init ls1x_serial_set_uartclk(struct platform_device *pdev)
49 {
50 struct clk *clk;
51 struct plat_serial8250_port *p;
52
53 clk = clk_get(&pdev->dev, pdev->name);
54 if (IS_ERR(clk)) {
55 pr_err("unable to get %s clock, err=%ld",
56 pdev->name, PTR_ERR(clk));
57 return;
58 }
59 clk_prepare_enable(clk);
60
61 for (p = pdev->dev.platform_data; p->flags != 0; ++p)
62 p->uartclk = clk_get_rate(clk);
63 }
64
65 /* CPUFreq */
66 static struct plat_ls1x_cpufreq ls1x_cpufreq_pdata = {
67 .clk_name = "cpu_clk",
68 .osc_clk_name = "osc_clk",
69 .max_freq = 266 * 1000,
70 .min_freq = 33 * 1000,
71 };
72
73 struct platform_device ls1x_cpufreq_pdev = {
74 .name = "ls1x-cpufreq",
75 .dev = {
76 .platform_data = &ls1x_cpufreq_pdata,
77 },
78 };
79
80 /* Synopsys Ethernet GMAC */
81 static struct stmmac_mdio_bus_data ls1x_mdio_bus_data = {
82 .phy_mask = 0,
83 };
84
85 static struct stmmac_dma_cfg ls1x_eth_dma_cfg = {
86 .pbl = 1,
87 };
88
ls1x_eth_mux_init(struct platform_device * pdev,void * priv)89 int ls1x_eth_mux_init(struct platform_device *pdev, void *priv)
90 {
91 struct plat_stmmacenet_data *plat_dat = NULL;
92 u32 val;
93
94 val = __raw_readl(LS1X_MUX_CTRL1);
95
96 #if defined(CONFIG_LOONGSON1_LS1B)
97 plat_dat = dev_get_platdata(&pdev->dev);
98 if (plat_dat->bus_id) {
99 __raw_writel(__raw_readl(LS1X_MUX_CTRL0) | GMAC1_USE_UART1 |
100 GMAC1_USE_UART0, LS1X_MUX_CTRL0);
101 switch (plat_dat->interface) {
102 case PHY_INTERFACE_MODE_RGMII:
103 val &= ~(GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
104 break;
105 case PHY_INTERFACE_MODE_MII:
106 val |= (GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
107 break;
108 default:
109 pr_err("unsupported mii mode %d\n",
110 plat_dat->interface);
111 return -ENOTSUPP;
112 }
113 val &= ~GMAC1_SHUT;
114 } else {
115 switch (plat_dat->interface) {
116 case PHY_INTERFACE_MODE_RGMII:
117 val &= ~(GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
118 break;
119 case PHY_INTERFACE_MODE_MII:
120 val |= (GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
121 break;
122 default:
123 pr_err("unsupported mii mode %d\n",
124 plat_dat->interface);
125 return -ENOTSUPP;
126 }
127 val &= ~GMAC0_SHUT;
128 }
129 __raw_writel(val, LS1X_MUX_CTRL1);
130 #elif defined(CONFIG_LOONGSON1_LS1C)
131 plat_dat = dev_get_platdata(&pdev->dev);
132
133 val &= ~PHY_INTF_SELI;
134 if (plat_dat->interface == PHY_INTERFACE_MODE_RMII)
135 val |= 0x4 << PHY_INTF_SELI_SHIFT;
136 __raw_writel(val, LS1X_MUX_CTRL1);
137
138 val = __raw_readl(LS1X_MUX_CTRL0);
139 __raw_writel(val & (~GMAC_SHUT), LS1X_MUX_CTRL0);
140 #endif
141
142 return 0;
143 }
144
145 static struct plat_stmmacenet_data ls1x_eth0_pdata = {
146 .bus_id = 0,
147 .phy_addr = -1,
148 #if defined(CONFIG_LOONGSON1_LS1B)
149 .interface = PHY_INTERFACE_MODE_MII,
150 #elif defined(CONFIG_LOONGSON1_LS1C)
151 .interface = PHY_INTERFACE_MODE_RMII,
152 #endif
153 .mdio_bus_data = &ls1x_mdio_bus_data,
154 .dma_cfg = &ls1x_eth_dma_cfg,
155 .has_gmac = 1,
156 .tx_coe = 1,
157 .rx_queues_to_use = 1,
158 .tx_queues_to_use = 1,
159 .init = ls1x_eth_mux_init,
160 };
161
162 static struct resource ls1x_eth0_resources[] = {
163 [0] = {
164 .start = LS1X_GMAC0_BASE,
165 .end = LS1X_GMAC0_BASE + SZ_64K - 1,
166 .flags = IORESOURCE_MEM,
167 },
168 [1] = {
169 .name = "macirq",
170 .start = LS1X_GMAC0_IRQ,
171 .flags = IORESOURCE_IRQ,
172 },
173 };
174
175 struct platform_device ls1x_eth0_pdev = {
176 .name = "stmmaceth",
177 .id = 0,
178 .num_resources = ARRAY_SIZE(ls1x_eth0_resources),
179 .resource = ls1x_eth0_resources,
180 .dev = {
181 .platform_data = &ls1x_eth0_pdata,
182 },
183 };
184
185 #ifdef CONFIG_LOONGSON1_LS1B
186 static struct plat_stmmacenet_data ls1x_eth1_pdata = {
187 .bus_id = 1,
188 .phy_addr = -1,
189 .interface = PHY_INTERFACE_MODE_MII,
190 .mdio_bus_data = &ls1x_mdio_bus_data,
191 .dma_cfg = &ls1x_eth_dma_cfg,
192 .has_gmac = 1,
193 .tx_coe = 1,
194 .rx_queues_to_use = 1,
195 .tx_queues_to_use = 1,
196 .init = ls1x_eth_mux_init,
197 };
198
199 static struct resource ls1x_eth1_resources[] = {
200 [0] = {
201 .start = LS1X_GMAC1_BASE,
202 .end = LS1X_GMAC1_BASE + SZ_64K - 1,
203 .flags = IORESOURCE_MEM,
204 },
205 [1] = {
206 .name = "macirq",
207 .start = LS1X_GMAC1_IRQ,
208 .flags = IORESOURCE_IRQ,
209 },
210 };
211
212 struct platform_device ls1x_eth1_pdev = {
213 .name = "stmmaceth",
214 .id = 1,
215 .num_resources = ARRAY_SIZE(ls1x_eth1_resources),
216 .resource = ls1x_eth1_resources,
217 .dev = {
218 .platform_data = &ls1x_eth1_pdata,
219 },
220 };
221 #endif /* CONFIG_LOONGSON1_LS1B */
222
223 /* GPIO */
224 static struct resource ls1x_gpio0_resources[] = {
225 [0] = {
226 .start = LS1X_GPIO0_BASE,
227 .end = LS1X_GPIO0_BASE + SZ_4 - 1,
228 .flags = IORESOURCE_MEM,
229 },
230 };
231
232 struct platform_device ls1x_gpio0_pdev = {
233 .name = "ls1x-gpio",
234 .id = 0,
235 .num_resources = ARRAY_SIZE(ls1x_gpio0_resources),
236 .resource = ls1x_gpio0_resources,
237 };
238
239 static struct resource ls1x_gpio1_resources[] = {
240 [0] = {
241 .start = LS1X_GPIO1_BASE,
242 .end = LS1X_GPIO1_BASE + SZ_4 - 1,
243 .flags = IORESOURCE_MEM,
244 },
245 };
246
247 struct platform_device ls1x_gpio1_pdev = {
248 .name = "ls1x-gpio",
249 .id = 1,
250 .num_resources = ARRAY_SIZE(ls1x_gpio1_resources),
251 .resource = ls1x_gpio1_resources,
252 };
253
254 /* USB EHCI */
255 static u64 ls1x_ehci_dmamask = DMA_BIT_MASK(32);
256
257 static struct resource ls1x_ehci_resources[] = {
258 [0] = {
259 .start = LS1X_EHCI_BASE,
260 .end = LS1X_EHCI_BASE + SZ_32K - 1,
261 .flags = IORESOURCE_MEM,
262 },
263 [1] = {
264 .start = LS1X_EHCI_IRQ,
265 .flags = IORESOURCE_IRQ,
266 },
267 };
268
269 static struct usb_ehci_pdata ls1x_ehci_pdata = {
270 };
271
272 struct platform_device ls1x_ehci_pdev = {
273 .name = "ehci-platform",
274 .id = -1,
275 .num_resources = ARRAY_SIZE(ls1x_ehci_resources),
276 .resource = ls1x_ehci_resources,
277 .dev = {
278 .dma_mask = &ls1x_ehci_dmamask,
279 .platform_data = &ls1x_ehci_pdata,
280 },
281 };
282
283 /* Real Time Clock */
ls1x_rtc_set_extclk(struct platform_device * pdev)284 void __init ls1x_rtc_set_extclk(struct platform_device *pdev)
285 {
286 u32 val = __raw_readl(LS1X_RTC_CTRL);
287
288 if (!(val & RTC_EXTCLK_OK))
289 __raw_writel(val | RTC_EXTCLK_EN, LS1X_RTC_CTRL);
290 }
291
292 struct platform_device ls1x_rtc_pdev = {
293 .name = "ls1x-rtc",
294 .id = -1,
295 };
296
297 /* Watchdog */
298 static struct resource ls1x_wdt_resources[] = {
299 {
300 .start = LS1X_WDT_BASE,
301 .end = LS1X_WDT_BASE + SZ_16 - 1,
302 .flags = IORESOURCE_MEM,
303 },
304 };
305
306 struct platform_device ls1x_wdt_pdev = {
307 .name = "ls1x-wdt",
308 .id = -1,
309 .num_resources = ARRAY_SIZE(ls1x_wdt_resources),
310 .resource = ls1x_wdt_resources,
311 };
312