1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3 * pata_oldpiix.c - Intel PATA/SATA controllers
4 *
5 * (C) 2005 Red Hat
6 *
7 * Some parts based on ata_piix.c by Jeff Garzik and others.
8 *
9 * Early PIIX differs significantly from the later PIIX as it lacks
10 * SITRE and the slave timing registers. This means that you have to
11 * set timing per channel, or be clever. Libata tells us whenever it
12 * does drive selection and we use this to reload the timings.
13 *
14 * Because of these behaviour differences PIIX gets its own driver module.
15 */
16
17 #include <linux/kernel.h>
18 #include <linux/module.h>
19 #include <linux/pci.h>
20 #include <linux/blkdev.h>
21 #include <linux/delay.h>
22 #include <linux/device.h>
23 #include <scsi/scsi_host.h>
24 #include <linux/libata.h>
25 #include <linux/ata.h>
26
27 #define DRV_NAME "pata_oldpiix"
28 #define DRV_VERSION "0.5.5"
29
30 /**
31 * oldpiix_pre_reset - probe begin
32 * @link: ATA link
33 * @deadline: deadline jiffies for the operation
34 *
35 * Set up cable type and use generic probe init
36 */
37
oldpiix_pre_reset(struct ata_link * link,unsigned long deadline)38 static int oldpiix_pre_reset(struct ata_link *link, unsigned long deadline)
39 {
40 struct ata_port *ap = link->ap;
41 struct pci_dev *pdev = to_pci_dev(ap->host->dev);
42 static const struct pci_bits oldpiix_enable_bits[] = {
43 { 0x41U, 1U, 0x80UL, 0x80UL }, /* port 0 */
44 { 0x43U, 1U, 0x80UL, 0x80UL }, /* port 1 */
45 };
46
47 if (!pci_test_config_bits(pdev, &oldpiix_enable_bits[ap->port_no]))
48 return -ENOENT;
49
50 return ata_sff_prereset(link, deadline);
51 }
52
53 /**
54 * oldpiix_set_piomode - Initialize host controller PATA PIO timings
55 * @ap: Port whose timings we are configuring
56 * @adev: Device whose timings we are configuring
57 *
58 * Set PIO mode for device, in host controller PCI config space.
59 *
60 * LOCKING:
61 * None (inherited from caller).
62 */
63
oldpiix_set_piomode(struct ata_port * ap,struct ata_device * adev)64 static void oldpiix_set_piomode (struct ata_port *ap, struct ata_device *adev)
65 {
66 unsigned int pio = adev->pio_mode - XFER_PIO_0;
67 struct pci_dev *dev = to_pci_dev(ap->host->dev);
68 unsigned int idetm_port= ap->port_no ? 0x42 : 0x40;
69 u16 idetm_data;
70 int control = 0;
71
72 /*
73 * See Intel Document 298600-004 for the timing programing rules
74 * for PIIX/ICH. Note that the early PIIX does not have the slave
75 * timing port at 0x44.
76 */
77
78 static const /* ISP RTC */
79 u8 timings[][2] = { { 0, 0 },
80 { 0, 0 },
81 { 1, 0 },
82 { 2, 1 },
83 { 2, 3 }, };
84
85 if (pio > 1)
86 control |= 1; /* TIME */
87 if (ata_pio_need_iordy(adev))
88 control |= 2; /* IE */
89
90 /* Intel specifies that the prefetch/posting is for disk only */
91 if (adev->class == ATA_DEV_ATA)
92 control |= 4; /* PPE */
93
94 pci_read_config_word(dev, idetm_port, &idetm_data);
95
96 /*
97 * Set PPE, IE and TIME as appropriate.
98 * Clear the other drive's timing bits.
99 */
100 if (adev->devno == 0) {
101 idetm_data &= 0xCCE0;
102 idetm_data |= control;
103 } else {
104 idetm_data &= 0xCC0E;
105 idetm_data |= (control << 4);
106 }
107 idetm_data |= (timings[pio][0] << 12) |
108 (timings[pio][1] << 8);
109 pci_write_config_word(dev, idetm_port, idetm_data);
110
111 /* Track which port is configured */
112 ap->private_data = adev;
113 }
114
115 /**
116 * oldpiix_set_dmamode - Initialize host controller PATA DMA timings
117 * @ap: Port whose timings we are configuring
118 * @adev: Device to program
119 *
120 * Set MWDMA mode for device, in host controller PCI config space.
121 *
122 * LOCKING:
123 * None (inherited from caller).
124 */
125
oldpiix_set_dmamode(struct ata_port * ap,struct ata_device * adev)126 static void oldpiix_set_dmamode (struct ata_port *ap, struct ata_device *adev)
127 {
128 struct pci_dev *dev = to_pci_dev(ap->host->dev);
129 u8 idetm_port = ap->port_no ? 0x42 : 0x40;
130 u16 idetm_data;
131
132 static const /* ISP RTC */
133 u8 timings[][2] = { { 0, 0 },
134 { 0, 0 },
135 { 1, 0 },
136 { 2, 1 },
137 { 2, 3 }, };
138
139 /*
140 * MWDMA is driven by the PIO timings. We must also enable
141 * IORDY unconditionally along with TIME1. PPE has already
142 * been set when the PIO timing was set.
143 */
144
145 unsigned int mwdma = adev->dma_mode - XFER_MW_DMA_0;
146 unsigned int control;
147 const unsigned int needed_pio[3] = {
148 XFER_PIO_0, XFER_PIO_3, XFER_PIO_4
149 };
150 int pio = needed_pio[mwdma] - XFER_PIO_0;
151
152 pci_read_config_word(dev, idetm_port, &idetm_data);
153
154 control = 3; /* IORDY|TIME0 */
155 /* Intel specifies that the PPE functionality is for disk only */
156 if (adev->class == ATA_DEV_ATA)
157 control |= 4; /* PPE enable */
158
159 /* If the drive MWDMA is faster than it can do PIO then
160 we must force PIO into PIO0 */
161
162 if (adev->pio_mode < needed_pio[mwdma])
163 /* Enable DMA timing only */
164 control |= 8; /* PIO cycles in PIO0 */
165
166 /* Mask out the relevant control and timing bits we will load. Also
167 clear the other drive TIME register as a precaution */
168 if (adev->devno == 0) {
169 idetm_data &= 0xCCE0;
170 idetm_data |= control;
171 } else {
172 idetm_data &= 0xCC0E;
173 idetm_data |= (control << 4);
174 }
175 idetm_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8);
176 pci_write_config_word(dev, idetm_port, idetm_data);
177
178 /* Track which port is configured */
179 ap->private_data = adev;
180 }
181
182 /**
183 * oldpiix_qc_issue - command issue
184 * @qc: command pending
185 *
186 * Called when the libata layer is about to issue a command. We wrap
187 * this interface so that we can load the correct ATA timings if
188 * necessary. Our logic also clears TIME0/TIME1 for the other device so
189 * that, even if we get this wrong, cycles to the other device will
190 * be made PIO0.
191 */
192
oldpiix_qc_issue(struct ata_queued_cmd * qc)193 static unsigned int oldpiix_qc_issue(struct ata_queued_cmd *qc)
194 {
195 struct ata_port *ap = qc->ap;
196 struct ata_device *adev = qc->dev;
197
198 if (adev != ap->private_data) {
199 oldpiix_set_piomode(ap, adev);
200 if (ata_dma_enabled(adev))
201 oldpiix_set_dmamode(ap, adev);
202 }
203 return ata_bmdma_qc_issue(qc);
204 }
205
206
207 static struct scsi_host_template oldpiix_sht = {
208 ATA_BMDMA_SHT(DRV_NAME),
209 };
210
211 static struct ata_port_operations oldpiix_pata_ops = {
212 .inherits = &ata_bmdma_port_ops,
213 .qc_issue = oldpiix_qc_issue,
214 .cable_detect = ata_cable_40wire,
215 .set_piomode = oldpiix_set_piomode,
216 .set_dmamode = oldpiix_set_dmamode,
217 .prereset = oldpiix_pre_reset,
218 };
219
220
221 /**
222 * oldpiix_init_one - Register PIIX ATA PCI device with kernel services
223 * @pdev: PCI device to register
224 * @ent: Entry in oldpiix_pci_tbl matching with @pdev
225 *
226 * Called from kernel PCI layer. We probe for combined mode (sigh),
227 * and then hand over control to libata, for it to do the rest.
228 *
229 * LOCKING:
230 * Inherited from PCI layer (may sleep).
231 *
232 * RETURNS:
233 * Zero on success, or -ERRNO value.
234 */
235
oldpiix_init_one(struct pci_dev * pdev,const struct pci_device_id * ent)236 static int oldpiix_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
237 {
238 static const struct ata_port_info info = {
239 .flags = ATA_FLAG_SLAVE_POSS,
240 .pio_mask = ATA_PIO4,
241 .mwdma_mask = ATA_MWDMA12_ONLY,
242 .port_ops = &oldpiix_pata_ops,
243 };
244 const struct ata_port_info *ppi[] = { &info, NULL };
245
246 ata_print_version_once(&pdev->dev, DRV_VERSION);
247
248 return ata_pci_bmdma_init_one(pdev, ppi, &oldpiix_sht, NULL, 0);
249 }
250
251 static const struct pci_device_id oldpiix_pci_tbl[] = {
252 { PCI_VDEVICE(INTEL, 0x1230), },
253
254 { } /* terminate list */
255 };
256
257 static struct pci_driver oldpiix_pci_driver = {
258 .name = DRV_NAME,
259 .id_table = oldpiix_pci_tbl,
260 .probe = oldpiix_init_one,
261 .remove = ata_pci_remove_one,
262 #ifdef CONFIG_PM_SLEEP
263 .suspend = ata_pci_device_suspend,
264 .resume = ata_pci_device_resume,
265 #endif
266 };
267
268 module_pci_driver(oldpiix_pci_driver);
269
270 MODULE_AUTHOR("Alan Cox");
271 MODULE_DESCRIPTION("SCSI low-level driver for early PIIX series controllers");
272 MODULE_LICENSE("GPL");
273 MODULE_DEVICE_TABLE(pci, oldpiix_pci_tbl);
274 MODULE_VERSION(DRV_VERSION);
275