1 2 DRAGONFLY CDROM README.USB 3 4 When booting from CDRom, the USB subsystem is not entirely activated 5 by the default boot, and while the primary USB and OHCI drivers are 6 loaded, the EHCI driver is not loaded and usbd is not started. This 7 is because USB is always a moving target and we want to ensure that 8 the CD actually boots. 9 10 To finish activating USB do the following at the root prompt: 11 12 kldload ehci.ko 13 rcforce usbd 14 15 If you have a lot of UMASS storage devices /dev may not have device 16 entries for all of them. DragonFly uses a pseudo SCSI layer to access 17 USB mass storage devices so if /dev/daX does not exist you can create 18 it with MAKEDEV: 19 20 cd /dev 21 ./MAKEDEV da4 da5 22 23 To enable USBD after installing on a hard disk, simply set 24 usbd_enable="YES" in /etc/rc.conf. 25 26$DragonFly: src/nrelease/root/README.USB,v 1.1 2004/03/17 19:19:17 dillon Exp $ 27 28