xref: /freebsd/sys/cam/ctl/ctl_ha.h (revision 5b9c547c)
1 /*-
2  * Copyright (c) 2003-2009 Silicon Graphics International Corp.
3  * Copyright (c) 2011 Spectra Logic Corporation
4  * All rights reserved.
5  *
6  * Redistribution and use in source and binary forms, with or without
7  * modification, are permitted provided that the following conditions
8  * are met:
9  * 1. Redistributions of source code must retain the above copyright
10  *    notice, this list of conditions, and the following disclaimer,
11  *    without modification.
12  * 2. Redistributions in binary form must reproduce at minimum a disclaimer
13  *    substantially similar to the "NO WARRANTY" disclaimer below
14  *    ("Disclaimer") and any redistribution must be conditioned upon
15  *    including a substantially similar Disclaimer requirement for further
16  *    binary redistribution.
17  *
18  * NO WARRANTY
19  * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
20  * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
21  * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR
22  * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
23  * HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
24  * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
25  * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
26  * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
27  * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING
28  * IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
29  * POSSIBILITY OF SUCH DAMAGES.
30  *
31  * $Id: //depot/users/kenm/FreeBSD-test2/sys/cam/ctl/ctl_ha.h#1 $
32  * $FreeBSD$
33  */
34 
35 #ifndef _CTL_HA_H_
36 #define	_CTL_HA_H_
37 
38 /*
39  * CTL High Availability Modes:
40  *
41  * CTL_HA_MODE_ACT_STBY:  One side is in Active state and processing commands,
42  *			  the other side is in Standby state, returning errors.
43  * CTL_HA_MODE_SER_ONLY:  Commands are serialized to the other side.  Write
44  *			  mirroring and read re-direction are assumed to
45  * 			  happen in the back end.
46  * CTL_HA_MODE_XFER:	  Commands are serialized and data is transferred
47  *			  for write mirroring and read re-direction.
48  */
49 
50 typedef enum {
51 	CTL_HA_MODE_ACT_STBY,
52 	CTL_HA_MODE_SER_ONLY,
53 	CTL_HA_MODE_XFER
54 } ctl_ha_mode;
55 
56 
57 /*
58  * This is a stubbed out High Availability interface.  It assumes two nodes
59  * staying in sync.
60  *
61  * The reason this interface is here, and stubbed out, is that CTL was
62  * originally written with support for Copan's (now SGI) high availability
63  * framework.  That framework was not released by SGI, and would not have
64  * been generally applicable to FreeBSD anyway.
65  *
66  * The idea here is to show the kind of API that would need to be in place
67  * in a HA framework to work with CTL's HA hooks.  This API is very close
68  * to the Copan/SGI API, so that the code using it could stay in place
69  * as-is.
70  *
71  * So, in summary, this is a shell without real substance, and much more
72  * work would be needed to actually make HA work.  The implementation
73  * inside CTL will also need to change to fit the eventual implementation.
74  * The additional pieces we would need are:
75  *
76  *  - HA "Supervisor" framework that can startup the components of the
77  *    system, and initiate failover (i.e. active/active to single mode)
78  *    and failback (single to active/active mode) state transitions.
79  *    This framework would be able to recognize when an event happens
80  *    that requires it to initiate state transitions in the components it
81  *    manages.
82  *
83  *  - HA communication framework.  This framework should have the following
84  *    features:
85  *	- Separate channels for separate system components.  The CTL
86  *	  instance on one node should communicate with the CTL instance
87  *	  on another node.
88  *	- Short message passing.  These messages would be fixed length, so
89  *	  they could be preallocated and easily passed between the nodes.
90  *	  i.e. conceptually like an ethernet packet.
91  *	- DMA/large buffer capability.  This would require some negotiation
92  *	  with the other node to define the destination.  It could
93  *	  allow for "push" (i.e. initiated by the requesting node) DMA or
94  * 	  "pull" (i.e. initiated by the target controller) DMA or both.
95  *	- Communication channel status change notification.
96  *  - HA capability in other portions of the storage stack.  Having two CTL
97  *    instances communicate is just one part of an overall HA solution.
98  *    State needs to be synchronized at multiple levels of the system in
99  *    order for failover to actually work.  For instance, if CTL is using a
100  *    file on a ZFS filesystem as its backing store, the ZFS array state
101  *    should be synchronized with the other node, so that the other node
102  *    can immediately take over if the node that is primary for a particular
103  *    array fails.
104  */
105 
106 /*
107  * Communication channel IDs for various system components.  This is to
108  * make sure one CTL instance talks with another, one ZFS instance talks
109  * with another, etc.
110  */
111 typedef enum {
112 	CTL_HA_CHAN_NONE,
113 	CTL_HA_CHAN_CTL,
114 	CTL_HA_CHAN_ZFS,
115 	CTL_HA_CHAN_MAX
116 } ctl_ha_channel;
117 
118 /*
119  * HA communication event notification.  These are events generated by the
120  * HA communication subsystem.
121  *
122  * CTL_HA_EVT_MSG_RECV:		Message received by the other node.
123  * CTL_HA_EVT_MSG_SENT:		Message sent to the other node.
124  * CTL_HA_EVT_DISCONNECT:	Communication channel disconnected.
125  * CTL_HA_EVT_DMA_SENT:		DMA successfully sent to other node (push).
126  * CTL_HA_EVT_DMA_RECEIVED:	DMA successfully received by other node (pull).
127  */
128 typedef enum {
129 	CTL_HA_EVT_NONE,
130 	CTL_HA_EVT_MSG_RECV,
131 	CTL_HA_EVT_MSG_SENT,
132 	CTL_HA_EVT_DISCONNECT,
133 	CTL_HA_EVT_DMA_SENT,
134 	CTL_HA_EVT_DMA_RECEIVED,
135 	CTL_HA_EVT_MAX
136 } ctl_ha_event;
137 
138 typedef enum {
139 	CTL_HA_STATUS_WAIT,
140 	CTL_HA_STATUS_SUCCESS,
141 	CTL_HA_STATUS_ERROR,
142 	CTL_HA_STATUS_INVALID,
143 	CTL_HA_STATUS_DISCONNECT,
144 	CTL_HA_STATUS_BUSY,
145 	CTL_HA_STATUS_MAX
146 } ctl_ha_status;
147 
148 typedef enum {
149 	CTL_HA_DATA_CTL,
150 	CTL_HA_DATA_ZFS,
151 	CTL_HA_DATA_MAX
152 } ctl_ha_dtid;
153 
154 typedef enum {
155 	CTL_HA_DT_CMD_READ,
156 	CTL_HA_DT_CMD_WRITE,
157 } ctl_ha_dt_cmd;
158 
159 struct ctl_ha_dt_req;
160 
161 typedef void (*ctl_ha_dt_cb)(struct ctl_ha_dt_req *);
162 
163 struct ctl_ha_dt_req {
164 	ctl_ha_dt_cmd	command;
165 	void		*context;
166 	ctl_ha_dt_cb	callback;
167 	ctl_ha_dtid	id;
168 	int		ret;
169 	uint32_t	size;
170 	uint8_t		*local;
171 	uint8_t		*remote;
172 };
173 
174 typedef void (*ctl_evt_handler)(ctl_ha_channel channel, ctl_ha_event event,
175 				int param);
176 void ctl_ha_register_evthandler(ctl_ha_channel channel,
177 				ctl_evt_handler handler);
178 
179 static inline ctl_ha_status
180 ctl_ha_msg_create(ctl_ha_channel channel, ctl_evt_handler handler)
181 {
182 	return (CTL_HA_STATUS_SUCCESS);
183 }
184 
185 /*
186  * Receive a message of the specified size.
187  */
188 static inline ctl_ha_status
189 ctl_ha_msg_recv(ctl_ha_channel channel, void *buffer, unsigned int size,
190 		int wait)
191 {
192 	return (CTL_HA_STATUS_SUCCESS);
193 }
194 
195 /*
196  * Send a message of the specified size.
197  */
198 static inline ctl_ha_status
199 ctl_ha_msg_send(ctl_ha_channel channel, void *buffer, unsigned int size,
200 		int wait)
201 {
202 	return (CTL_HA_STATUS_SUCCESS);
203 }
204 
205 /*
206  * Allocate a data transfer request structure.
207  */
208 static inline struct ctl_ha_dt_req *
209 ctl_dt_req_alloc(void)
210 {
211 	return (NULL);
212 }
213 
214 /*
215  * Free a data transfer request structure.
216  */
217 static inline void
218 ctl_dt_req_free(struct ctl_ha_dt_req *req)
219 {
220 	return;
221 }
222 
223 /*
224  * Issue a DMA request for a single buffer.
225  */
226 static inline ctl_ha_status
227 ctl_dt_single(struct ctl_ha_dt_req *req)
228 {
229 	return (CTL_HA_STATUS_WAIT);
230 }
231 
232 /*
233  * SINGLE:	   One node
234  * HA:		   Two nodes (Active/Active implied)
235  * SLAVE/MASTER:   The component can set these flags to indicate which side
236  *		   is in control.  It has no effect on the HA framework.
237  */
238 typedef enum {
239 	CTL_HA_STATE_UNKNOWN	= 0x00,
240 	CTL_HA_STATE_SINGLE	= 0x01,
241 	CTL_HA_STATE_HA		= 0x02,
242 	CTL_HA_STATE_MASK	= 0x0F,
243 	CTL_HA_STATE_SLAVE	= 0x10,
244 	CTL_HA_STATE_MASTER	= 0x20
245 } ctl_ha_state;
246 
247 typedef enum {
248 	CTL_HA_COMP_STATUS_OK,
249 	CTL_HA_COMP_STATUS_FAILED,
250 	CTL_HA_COMP_STATUS_ERROR
251 } ctl_ha_comp_status;
252 
253 struct ctl_ha_component;
254 
255 typedef ctl_ha_comp_status (*ctl_hacmp_init_t)(struct ctl_ha_component *);
256 typedef ctl_ha_comp_status (*ctl_hacmp_start_t)(struct ctl_ha_component *,
257 						ctl_ha_state);
258 
259 struct ctl_ha_component {
260 	char			*name;
261 	ctl_ha_state 		state;
262 	ctl_ha_comp_status	status;
263 	ctl_hacmp_init_t	init;
264 	ctl_hacmp_start_t	start;
265 	ctl_hacmp_init_t	quiesce;
266 };
267 
268 #define	CTL_HA_STATE_IS_SINGLE(state)	((state & CTL_HA_STATE_MASK) == \
269 					  CTL_HA_STATE_SINGLE)
270 #define	CTL_HA_STATE_IS_HA(state)	((state & CTL_HA_STATE_MASK) == \
271 					  CTL_HA_STATE_HA)
272 
273 #endif /* _CTL_HA_H_ */
274