1Mediatek MT7621 SoC GPIO controller bindings
2
3The IP core used inside these SoCs has 3 banks of 32 GPIOs each.
4The registers of all the banks are interwoven inside one single IO range.
5We load one GPIO controller instance per bank. Also the GPIO controller can receive
6interrupts on any of the GPIOs, either edge or level. It then interrupts the CPU
7using GIC INT12.
8
9Required properties for the top level node:
10- #gpio-cells : Should be two. The first cell is the GPIO pin number and the
11   second cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>.
12   Only the GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported.
13- #interrupt-cells : Specifies the number of cells needed to encode an
14   interrupt. Should be 2. The first cell defines the interrupt number,
15   the second encodes the trigger flags encoded as described in
16   Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
17- compatible:
18  - "mediatek,mt7621-gpio" for Mediatek controllers
19- reg : Physical base address and length of the controller's registers
20- interrupt-parent : phandle of the parent interrupt controller.
21- interrupts : Interrupt specifier for the controllers interrupt.
22- interrupt-controller : Mark the device node as an interrupt controller.
23- gpio-controller : Marks the device node as a GPIO controller.
24
25Example:
26	gpio@600 {
27		#gpio-cells = <2>;
28		#interrupt-cells = <2>;
29		compatible = "mediatek,mt7621-gpio";
30		gpio-controller;
31		interrupt-controller;
32		reg = <0x600 0x100>;
33		interrupt-parent = <&gic>;
34		interrupts = <GIC_SHARED 12 IRQ_TYPE_LEVEL_HIGH>;
35	};
36