1Properties for an MDIO bus multiplexer controlled by a memory-mapped device
2
3This is a special case of a MDIO bus multiplexer.  A memory-mapped device,
4like an FPGA, is used to control which child bus is connected.  The mdio-mux
5node must be a child of the memory-mapped device.  The driver currently only
6supports devices with 8, 16 or 32-bit registers.
7
8Required properties in addition to the generic multiplexer properties:
9
10- compatible : string, must contain "mdio-mux-mmioreg"
11
12- reg : integer, contains the offset of the register that controls the bus
13	multiplexer.  The size field in the 'reg' property is the size of
14	register, and must therefore be 1, 2, or 4.
15
16- mux-mask : integer, contains an eight-bit mask that specifies which
17	bits in the register control the actual bus multiplexer.  The
18	'reg' property of each child mdio-mux node must be constrained by
19	this mask.
20
21Example:
22
23The FPGA node defines a memory-mapped FPGA with a register space of 0x30 bytes.
24For the "EMI2" MDIO bus, register 9 (BRDCFG1) controls the mux on that bus.
25A bitmask of 0x6 means that bits 1 and 2 (bit 0 is lsb) are the bits on
26BRDCFG1 that control the actual mux.
27
28	/* The FPGA node */
29	fpga: board-control@3,0 {
30		#address-cells = <1>;
31		#size-cells = <1>;
32		compatible = "fsl,p5020ds-fpga", "fsl,fpga-ngpixis";
33		reg = <3 0 0x30>;
34		ranges = <0 3 0 0x30>;
35
36		mdio-mux-emi2 {
37			compatible = "mdio-mux-mmioreg", "mdio-mux";
38			mdio-parent-bus = <&xmdio0>;
39			#address-cells = <1>;
40			#size-cells = <0>;
41			reg = <9 1>; // BRDCFG1
42			mux-mask = <0x6>; // EMI2
43
44			emi2_slot1: mdio@0 {	// Slot 1 XAUI (FM2)
45				reg = <0>;
46				#address-cells = <1>;
47				#size-cells = <0>;
48
49				phy_xgmii_slot1: ethernet-phy@0 {
50					compatible = "ethernet-phy-ieee802.3-c45";
51					reg = <4>;
52				};
53			};
54
55			emi2_slot2: mdio@2 {	// Slot 2 XAUI (FM1)
56				reg = <2>;
57				#address-cells = <1>;
58				#size-cells = <0>;
59
60				phy_xgmii_slot2: ethernet-phy@4 {
61					compatible = "ethernet-phy-ieee802.3-c45";
62					reg = <0>;
63				};
64			};
65		};
66	};
67
68	/* The parent MDIO bus. */
69	xmdio0: mdio@f1000 {
70		#address-cells = <1>;
71		#size-cells = <0>;
72		compatible = "fsl,fman-xmdio";
73		reg = <0xf1000 0x1000>;
74		interrupts = <100 1 0 0>;
75	};
76