1OMAP UART controller
2
3Required properties:
4- compatible : should be "ti,am64-uart", "ti,am654-uart" for AM64 controllers
5- compatible : should be "ti,j721e-uart", "ti,am654-uart" for J721E controllers
6- compatible : should be "ti,am654-uart" for AM654 controllers
7- compatible : should be "ti,omap2-uart" for OMAP2 controllers
8- compatible : should be "ti,omap3-uart" for OMAP3 controllers
9- compatible : should be "ti,omap4-uart" for OMAP4 controllers
10- compatible : should be "ti,am4372-uart" for AM437x controllers
11- compatible : should be "ti,am3352-uart" for AM335x controllers
12- compatible : should be "ti,dra742-uart" for DRA7x controllers
13- reg : address and length of the register space
14- interrupts or interrupts-extended : Should contain the uart interrupt
15                                      specifier or both the interrupt
16                                      controller phandle and interrupt
17                                      specifier.
18- ti,hwmods : Must be "uart<n>", n being the instance number (1-based)
19
20Optional properties:
21- clock-frequency : frequency of the clock input to the UART
22- dmas : DMA specifier, consisting of a phandle to the DMA controller
23         node and a DMA channel number.
24- dma-names : "rx" for receive channel, "tx" for transmit channel.
25- rs485-rts-delay, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt
26- rs485-rts-active-high: drive RTS high when sending (default is low).
27- clocks: phandle to the functional clock as per
28  Documentation/devicetree/bindings/clock/clock-bindings.txt
29
30Example:
31
32                uart4: serial@49042000 {
33                        compatible = "ti,omap3-uart";
34                        reg = <0x49042000 0x400>;
35                        interrupts = <80>;
36                        dmas = <&sdma 81 &sdma 82>;
37                        dma-names = "tx", "rx";
38                        ti,hwmods = "uart4";
39                        clock-frequency = <48000000>;
40                };
41