1 /*
2   Copyright (c), 2004-2005,2007-2010 Trident Microsystems, Inc.
3   All rights reserved.
4 
5   Redistribution and use in source and binary forms, with or without
6   modification, are permitted provided that the following conditions are met:
7 
8   * Redistributions of source code must retain the above copyright notice,
9     this list of conditions and the following disclaimer.
10   * Redistributions in binary form must reproduce the above copyright notice,
11     this list of conditions and the following disclaimer in the documentation
12 	and/or other materials provided with the distribution.
13   * Neither the name of Trident Microsystems nor Hauppauge Computer Works
14     nor the names of its contributors may be used to endorse or promote
15 	products derived from this software without specific prior written
16 	permission.
17 
18   THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
19   AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
20   IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
21   ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE
22   LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
23   CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
24   SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
25   INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
26   CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
27   ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
28   POSSIBILITY OF SUCH DAMAGE.
29 */
30 
31 /*******************************************************************************
32 * FILENAME: $Id: drx_dap_fasi.h,v 1.5 2009/07/07 14:21:40 justin Exp $
33 *
34 * DESCRIPTION:
35 * Part of DRX driver.
36 * Data access protocol: Fast Access Sequential Interface (fasi)
37 * Fast access, because of short addressing format (16 instead of 32 bits addr)
38 * Sequential, because of I2C.
39 *
40 * USAGE:
41 * Include.
42 *
43 * NOTES:
44 *
45 *
46 *******************************************************************************/
47 
48 /*-------- compilation control switches --------------------------------------*/
49 
50 #ifndef __DRX_DAP_FASI_H__
51 #define __DRX_DAP_FASI_H__
52 
53 /*-------- Required includes -------------------------------------------------*/
54 
55 #include "drx_driver.h"
56 
57 /*-------- Defines, configuring the API --------------------------------------*/
58 
59 /********************************************
60 * Allowed address formats
61 ********************************************/
62 
63 /*
64 * Comments about short/long addressing format:
65 *
66 * The DAP FASI offers long address format (4 bytes) and short address format
67 * (2 bytes). The DAP can operate in 3 modes:
68 * (1) only short
69 * (2) only long
70 * (3) both long and short but short preferred and long only when necessary
71 *
72 * These modes must be selected compile time via compile switches.
73 * Compile switch settings for the different modes:
74 * (1) DRXDAPFASI_LONG_ADDR_ALLOWED=0, DRXDAPFASI_SHORT_ADDR_ALLOWED=1
75 * (2) DRXDAPFASI_LONG_ADDR_ALLOWED=1, DRXDAPFASI_SHORT_ADDR_ALLOWED=0
76 * (3) DRXDAPFASI_LONG_ADDR_ALLOWED=1, DRXDAPFASI_SHORT_ADDR_ALLOWED=1
77 *
78 * The default setting will be (3) both long and short.
79 * The default setting will need no compile switches.
80 * The default setting must be overridden if compile switches are already
81 * defined.
82 *
83 */
84 
85 /* set default */
86 #if !defined(DRXDAPFASI_LONG_ADDR_ALLOWED)
87 #define  DRXDAPFASI_LONG_ADDR_ALLOWED 1
88 #endif
89 
90 /* set default */
91 #if !defined(DRXDAPFASI_SHORT_ADDR_ALLOWED)
92 #define  DRXDAPFASI_SHORT_ADDR_ALLOWED 1
93 #endif
94 
95 /* check */
96 #if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && \
97       (DRXDAPFASI_SHORT_ADDR_ALLOWED == 0))
98 #error  At least one of short- or long-addressing format must be allowed.
99 *;				/* illegal statement to force compiler error */
100 #endif
101 
102 /********************************************
103 * Single/master multi master setting
104 ********************************************/
105 /*
106 * Comments about SINGLE MASTER/MULTI MASTER  modes:
107 *
108 * Consider the two sides:1) the master and 2)the slave.
109 *
110 * Master:
111 * Single/multimaster operation set via DRXDAP_SINGLE_MASTER compile switch
112 *  + single master mode means no use of repeated starts
113 *  + multi master mode means use of repeated starts
114 *  Default is single master.
115 *  Default can be overridden by setting the compile switch DRXDAP_SINGLE_MASTER.
116 *
117 * Slave:
118 * Single/multi master selected via the flags in the FASI protocol.
119 *  + single master means remember memory address between i2c packets
120 *  + multimaster means flush memory address between i2c packets
121 *  Default is single master, DAP FASI changes multi-master setting silently
122 *  into single master setting. This cannot be overridden.
123 *
124 */
125 /* set default */
126 #ifndef DRXDAP_SINGLE_MASTER
127 #define DRXDAP_SINGLE_MASTER 0
128 #endif
129 
130 /********************************************
131 * Chunk/mode checking
132 ********************************************/
133 /*
134 * Comments about DRXDAP_MAX_WCHUNKSIZE in single or multi master mode and
135 * in combination with short and long addressing format. All text below
136 * assumes long addressing format. The table also includes information
137 * for short ADDRessing format.
138 *
139 * In single master mode, data can be written by sending the register address
140 * first, then two or four bytes of data in the next packet.
141 * Because the device address plus a register address equals five bytes,
142 * the minimum chunk size must be five.
143 * If ten-bit I2C device addresses are used, the minimum chunk size must be six,
144 * because the I2C device address will then occupy two bytes when writing.
145 *
146 * Data in single master mode is transferred as follows:
147 * <S> <devW>  a0  a1  a2  a3  <P>
148 * <S> <devW>  d0  d1 [d2  d3] <P>
149 * ..
150 * or
151 * ..
152 * <S> <devW>  a0  a1  a2  a3  <P>
153 * <S> <devR> --- <P>
154 *
155 * In multi-master mode, the data must immediately follow the address (an I2C
156 * stop resets the internal address), and hence the minimum chunk size is
157 * 1 <I2C address> + 4 (register address) + 2 (data to send) = 7 bytes (8 if
158 * 10-bit I2C device addresses are used).
159 *
160 * The 7-bit or 10-bit i2c address parameters is a runtime parameter.
161 * The other parameters can be limited via compile time switches.
162 *
163 *-------------------------------------------------------------------------------
164 *
165 *  Minimum chunk size table (in bytes):
166 *
167 *       +----------------+----------------+
168 *       | 7b i2c addr    | 10b i2c addr   |
169 *       +----------------+----------------+
170 *       | single | multi | single | multi |
171 * ------+--------+-------+--------+-------+
172 * short | 3      | 5     | 4      | 6     |
173 * long  | 5      | 7     | 6      | 8     |
174 * ------+--------+-------+--------+-------+
175 *
176 */
177 
178 /* set default */
179 #if !defined(DRXDAP_MAX_WCHUNKSIZE)
180 #define  DRXDAP_MAX_WCHUNKSIZE 254
181 #endif
182 
183 /* check */
184 #if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && (DRXDAPFASI_SHORT_ADDR_ALLOWED == 1))
185 #if DRXDAP_SINGLE_MASTER
186 #define  DRXDAP_MAX_WCHUNKSIZE_MIN 3
187 #else
188 #define  DRXDAP_MAX_WCHUNKSIZE_MIN 5
189 #endif
190 #else
191 #if DRXDAP_SINGLE_MASTER
192 #define  DRXDAP_MAX_WCHUNKSIZE_MIN 5
193 #else
194 #define  DRXDAP_MAX_WCHUNKSIZE_MIN 7
195 #endif
196 #endif
197 
198 #if  DRXDAP_MAX_WCHUNKSIZE <  DRXDAP_MAX_WCHUNKSIZE_MIN
199 #if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && (DRXDAPFASI_SHORT_ADDR_ALLOWED == 1))
200 #if DRXDAP_SINGLE_MASTER
201 #error  DRXDAP_MAX_WCHUNKSIZE must be at least 3 in single master mode
202 *;				/* illegal statement to force compiler error */
203 #else
204 #error  DRXDAP_MAX_WCHUNKSIZE must be at least 5 in multi master mode
205 *;				/* illegal statement to force compiler error */
206 #endif
207 #else
208 #if DRXDAP_SINGLE_MASTER
209 #error  DRXDAP_MAX_WCHUNKSIZE must be at least 5 in single master mode
210 *;				/* illegal statement to force compiler error */
211 #else
212 #error  DRXDAP_MAX_WCHUNKSIZE must be at least 7 in multi master mode
213 *;				/* illegal statement to force compiler error */
214 #endif
215 #endif
216 #endif
217 
218 /* set default */
219 #if !defined(DRXDAP_MAX_RCHUNKSIZE)
220 #define  DRXDAP_MAX_RCHUNKSIZE 254
221 #endif
222 
223 /* check */
224 #if  DRXDAP_MAX_RCHUNKSIZE < 2
225 #error  DRXDAP_MAX_RCHUNKSIZE must be at least 2
226 *;				/* illegal statement to force compiler error */
227 #endif
228 
229 /* check */
230 #if  DRXDAP_MAX_RCHUNKSIZE & 1
231 #error  DRXDAP_MAX_RCHUNKSIZE must be even
232 *;				/* illegal statement to force compiler error */
233 #endif
234 
235 /*-------- Public API functions ----------------------------------------------*/
236 
237 extern struct drx_access_func drx_dap_fasi_funct_g;
238 
239 #define DRXDAP_FASI_RMW           0x10000000
240 #define DRXDAP_FASI_BROADCAST     0x20000000
241 #define DRXDAP_FASI_CLEARCRC      0x80000000
242 #define DRXDAP_FASI_SINGLE_MASTER 0xC0000000
243 #define DRXDAP_FASI_MULTI_MASTER  0x40000000
244 #define DRXDAP_FASI_SMM_SWITCH    0x40000000	/* single/multi master switch */
245 #define DRXDAP_FASI_MODEFLAGS     0xC0000000
246 #define DRXDAP_FASI_FLAGS         0xF0000000
247 
248 #define DRXDAP_FASI_ADDR2BLOCK(addr)  (((addr)>>22)&0x3F)
249 #define DRXDAP_FASI_ADDR2BANK(addr)   (((addr)>>16)&0x3F)
250 #define DRXDAP_FASI_ADDR2OFFSET(addr) ((addr)&0x7FFF)
251 
252 #define DRXDAP_FASI_SHORT_FORMAT(addr)     (((addr) & 0xFC30FF80) == 0)
253 #define DRXDAP_FASI_LONG_FORMAT(addr)      (((addr) & 0xFC30FF80) != 0)
254 #define DRXDAP_FASI_OFFSET_TOO_LARGE(addr) (((addr) & 0x00008000) != 0)
255 
256 #endif				/* __DRX_DAP_FASI_H__ */
257