xref: /linux/drivers/pcmcia/ricoh.h (revision 0be3ff0c)
1 /*
2  * ricoh.h 1.9 1999/10/25 20:03:34
3  *
4  * The contents of this file are subject to the Mozilla Public License
5  * Version 1.1 (the "License"); you may not use this file except in
6  * compliance with the License. You may obtain a copy of the License
7  * at http://www.mozilla.org/MPL/
8  *
9  * Software distributed under the License is distributed on an "AS IS"
10  * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
11  * the License for the specific language governing rights and
12  * limitations under the License.
13  *
14  * The initial developer of the original code is David A. Hinds
15  * <dahinds@users.sourceforge.net>.  Portions created by David A. Hinds
16  * are Copyright (C) 1999 David A. Hinds.  All Rights Reserved.
17  *
18  * Alternatively, the contents of this file may be used under the
19  * terms of the GNU General Public License version 2 (the "GPL"), in which
20  * case the provisions of the GPL are applicable instead of the
21  * above.  If you wish to allow the use of your version of this file
22  * only under the terms of the GPL and not to allow others to use
23  * your version of this file under the MPL, indicate your decision by
24  * deleting the provisions above and replace them with the notice and
25  * other provisions required by the GPL.  If you do not delete the
26  * provisions above, a recipient may use your version of this file
27  * under either the MPL or the GPL.
28  */
29 
30 #ifndef _LINUX_RICOH_H
31 #define _LINUX_RICOH_H
32 
33 
34 #define RF5C_MODE_CTL		0x1f	/* Mode control */
35 #define RF5C_PWR_CTL		0x2f	/* Mixed voltage control */
36 #define RF5C_CHIP_ID		0x3a	/* Chip identification */
37 #define RF5C_MODE_CTL_3		0x3b	/* Mode control 3 */
38 
39 /* I/O window address offset */
40 #define RF5C_IO_OFF(w)		(0x36+((w)<<1))
41 
42 /* Flags for RF5C_MODE_CTL */
43 #define RF5C_MODE_ATA		0x01	/* ATA mode */
44 #define RF5C_MODE_LED_ENA	0x02	/* IRQ 12 is LED */
45 #define RF5C_MODE_CA21		0x04
46 #define RF5C_MODE_CA22		0x08
47 #define RF5C_MODE_CA23		0x10
48 #define RF5C_MODE_CA24		0x20
49 #define RF5C_MODE_CA25		0x40
50 #define RF5C_MODE_3STATE_BIT7	0x80
51 
52 /* Flags for RF5C_PWR_CTL */
53 #define RF5C_PWR_VCC_3V		0x01
54 #define RF5C_PWR_IREQ_HIGH	0x02
55 #define RF5C_PWR_INPACK_ENA	0x04
56 #define RF5C_PWR_5V_DET		0x08
57 #define RF5C_PWR_TC_SEL		0x10	/* Terminal Count: irq 11 or 15 */
58 #define RF5C_PWR_DREQ_LOW	0x20
59 #define RF5C_PWR_DREQ_OFF	0x00	/* DREQ steering control */
60 #define RF5C_PWR_DREQ_INPACK	0x40
61 #define RF5C_PWR_DREQ_SPKR	0x80
62 #define RF5C_PWR_DREQ_IOIS16	0xc0
63 
64 /* Values for RF5C_CHIP_ID */
65 #define RF5C_CHIP_RF5C296	0x32
66 #define RF5C_CHIP_RF5C396	0xb2
67 
68 /* Flags for RF5C_MODE_CTL_3 */
69 #define RF5C_MCTL3_DISABLE	0x01	/* Disable PCMCIA interface */
70 #define RF5C_MCTL3_DMA_ENA	0x02
71 
72 /* Register definitions for Ricoh PCI-to-CardBus bridges */
73 
74 /* Extra bits in CB_BRIDGE_CONTROL */
75 #define RL5C46X_BCR_3E0_ENA		0x0800
76 #define RL5C46X_BCR_3E2_ENA		0x1000
77 
78 /* Bridge Configuration Register */
79 #define RL5C4XX_CONFIG			0x80	/* 16 bit */
80 #define  RL5C4XX_CONFIG_IO_1_MODE	0x0200
81 #define  RL5C4XX_CONFIG_IO_0_MODE	0x0100
82 #define  RL5C4XX_CONFIG_PREFETCH	0x0001
83 
84 /* Misc Control Register */
85 #define RL5C4XX_MISC			0x0082	/* 16 bit */
86 #define  RL5C4XX_MISC_HW_SUSPEND_ENA	0x0002
87 #define  RL5C4XX_MISC_VCCEN_POL		0x0100
88 #define  RL5C4XX_MISC_VPPEN_POL		0x0200
89 #define  RL5C46X_MISC_SUSPEND		0x0001
90 #define  RL5C46X_MISC_PWR_SAVE_2	0x0004
91 #define  RL5C46X_MISC_IFACE_BUSY	0x0008
92 #define  RL5C46X_MISC_B_LOCK		0x0010
93 #define  RL5C46X_MISC_A_LOCK		0x0020
94 #define  RL5C46X_MISC_PCI_LOCK		0x0040
95 #define  RL5C47X_MISC_IFACE_BUSY	0x0004
96 #define  RL5C47X_MISC_PCI_INT_MASK	0x0018
97 #define  RL5C47X_MISC_PCI_INT_DIS	0x0020
98 #define  RL5C47X_MISC_SUBSYS_WR		0x0040
99 #define  RL5C47X_MISC_SRIRQ_ENA		0x0080
100 #define  RL5C47X_MISC_5V_DISABLE	0x0400
101 #define  RL5C47X_MISC_LED_POL		0x0800
102 
103 /* 16-bit Interface Control Register */
104 #define RL5C4XX_16BIT_CTL		0x0084	/* 16 bit */
105 #define  RL5C4XX_16CTL_IO_TIMING	0x0100
106 #define  RL5C4XX_16CTL_MEM_TIMING	0x0200
107 #define  RL5C46X_16CTL_LEVEL_1		0x0010
108 #define  RL5C46X_16CTL_LEVEL_2		0x0020
109 
110 /* 16-bit IO and memory timing registers */
111 #define RL5C4XX_16BIT_IO_0		0x0088	/* 16 bit */
112 #define RL5C4XX_16BIT_MEM_0		0x008a	/* 16 bit */
113 #define  RL5C4XX_SETUP_MASK		0x0007
114 #define  RL5C4XX_SETUP_SHIFT		0
115 #define  RL5C4XX_CMD_MASK		0x01f0
116 #define  RL5C4XX_CMD_SHIFT		4
117 #define  RL5C4XX_HOLD_MASK		0x1c00
118 #define  RL5C4XX_HOLD_SHIFT		10
119 #define  RL5C4XX_MISC_CONTROL           0x2F /* 8 bit */
120 #define  RL5C4XX_ZV_ENABLE              0x08
121 
122 /* Misc Control 3 Register */
123 #define RL5C4XX_MISC3			0x00A2 /* 16 bit */
124 #define  RL5C47X_MISC3_CB_CLKRUN_DIS	BIT(1)
125 
126 #ifdef __YENTA_H
127 
128 #define rl_misc(socket)		((socket)->private[0])
129 #define rl_ctl(socket)		((socket)->private[1])
130 #define rl_io(socket)		((socket)->private[2])
131 #define rl_mem(socket)		((socket)->private[3])
132 #define rl_config(socket)	((socket)->private[4])
133 
134 static void ricoh_zoom_video(struct pcmcia_socket *sock, int onoff)
135 {
136         u8 reg;
137 	struct yenta_socket *socket = container_of(sock, struct yenta_socket, socket);
138 
139         reg = config_readb(socket, RL5C4XX_MISC_CONTROL);
140         if (onoff)
141                 /* Zoom zoom, we will all go together, zoom zoom, zoom zoom */
142                 reg |=  RL5C4XX_ZV_ENABLE;
143         else
144                 reg &= ~RL5C4XX_ZV_ENABLE;
145 
146         config_writeb(socket, RL5C4XX_MISC_CONTROL, reg);
147 }
148 
149 static void ricoh_set_zv(struct yenta_socket *socket)
150 {
151         if(socket->dev->vendor == PCI_VENDOR_ID_RICOH)
152         {
153                 switch(socket->dev->device)
154                 {
155                         /* There may be more .. */
156 		case  PCI_DEVICE_ID_RICOH_RL5C478:
157 			socket->socket.zoom_video = ricoh_zoom_video;
158 			break;
159                 }
160         }
161 }
162 
163 static void ricoh_set_clkrun(struct yenta_socket *socket, bool quiet)
164 {
165 	u16 misc3;
166 
167 	/*
168 	 * RL5C475II likely has this setting, too, however no datasheet
169 	 * is publicly available for this chip
170 	 */
171 	if (socket->dev->device != PCI_DEVICE_ID_RICOH_RL5C476 &&
172 	    socket->dev->device != PCI_DEVICE_ID_RICOH_RL5C478)
173 		return;
174 
175 	if (socket->dev->revision < 0x80)
176 		return;
177 
178 	misc3 = config_readw(socket, RL5C4XX_MISC3);
179 	if (misc3 & RL5C47X_MISC3_CB_CLKRUN_DIS) {
180 		if (!quiet)
181 			dev_dbg(&socket->dev->dev,
182 				"CLKRUN feature already disabled\n");
183 	} else if (disable_clkrun) {
184 		if (!quiet)
185 			dev_info(&socket->dev->dev,
186 				 "Disabling CLKRUN feature\n");
187 		misc3 |= RL5C47X_MISC3_CB_CLKRUN_DIS;
188 		config_writew(socket, RL5C4XX_MISC3, misc3);
189 	}
190 }
191 
192 static void ricoh_save_state(struct yenta_socket *socket)
193 {
194 	rl_misc(socket) = config_readw(socket, RL5C4XX_MISC);
195 	rl_ctl(socket) = config_readw(socket, RL5C4XX_16BIT_CTL);
196 	rl_io(socket) = config_readw(socket, RL5C4XX_16BIT_IO_0);
197 	rl_mem(socket) = config_readw(socket, RL5C4XX_16BIT_MEM_0);
198 	rl_config(socket) = config_readw(socket, RL5C4XX_CONFIG);
199 }
200 
201 static void ricoh_restore_state(struct yenta_socket *socket)
202 {
203 	config_writew(socket, RL5C4XX_MISC, rl_misc(socket));
204 	config_writew(socket, RL5C4XX_16BIT_CTL, rl_ctl(socket));
205 	config_writew(socket, RL5C4XX_16BIT_IO_0, rl_io(socket));
206 	config_writew(socket, RL5C4XX_16BIT_MEM_0, rl_mem(socket));
207 	config_writew(socket, RL5C4XX_CONFIG, rl_config(socket));
208 	ricoh_set_clkrun(socket, true);
209 }
210 
211 
212 /*
213  * Magic Ricoh initialization code..
214  */
215 static int ricoh_override(struct yenta_socket *socket)
216 {
217 	u16 config, ctl;
218 
219 	config = config_readw(socket, RL5C4XX_CONFIG);
220 
221 	/* Set the default timings, don't trust the original values */
222 	ctl = RL5C4XX_16CTL_IO_TIMING | RL5C4XX_16CTL_MEM_TIMING;
223 
224 	if(socket->dev->device < PCI_DEVICE_ID_RICOH_RL5C475) {
225 		ctl |= RL5C46X_16CTL_LEVEL_1 | RL5C46X_16CTL_LEVEL_2;
226 	} else {
227 		config |= RL5C4XX_CONFIG_PREFETCH;
228 	}
229 
230 	config_writew(socket, RL5C4XX_16BIT_CTL, ctl);
231 	config_writew(socket, RL5C4XX_CONFIG, config);
232 
233 	ricoh_set_zv(socket);
234 	ricoh_set_clkrun(socket, false);
235 
236 	return 0;
237 }
238 
239 #endif /* CONFIG_CARDBUS */
240 
241 #endif /* _LINUX_RICOH_H */
242