1 /* $NetBSD: ihphyreg.h,v 1.1 2010/11/27 20:15:27 christos Exp $ */ 2 3 /*- 4 * Copyright (c) 2010 The NetBSD Foundation, Inc. 5 * All rights reserved. 6 * 7 * Redistribution and use in source and binary forms, with or without 8 * modification, are permitted provided that the following conditions 9 * are met: 10 * 1. Redistributions of source code must retain the above copyright 11 * notice, this list of conditions and the following disclaimer. 12 * 2. Redistributions in binary form must reproduce the above copyright 13 * notice, this list of conditions and the following disclaimer in the 14 * documentation and/or other materials provided with the distribution. 15 * 16 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 17 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 18 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 19 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 20 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 21 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 22 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 23 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 24 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 25 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 26 * POSSIBILITY OF SUCH DAMAGE. 27 */ 28 29 #ifndef _DEV_MII_IHPHYREG_H_ 30 #define _DEV_MII_IHPHYREG_H_ 31 32 #include <dev/mii/inbmphyreg.h> 33 34 /* 35 * Intel 82577LM registers. 36 */ 37 38 /* PHY Control Register 2 */ 39 #define IHPHY_MII_ECR2 BME1000_REG(0, 18) 40 41 /* Loopback Control Register */ 42 #define IHPHY_MII_LCR BME1000_REG(0, 19) 43 44 /* RX Error Counter Register */ 45 #define IHPHY_MII_RXERR BME1000_REG(0, 20) 46 47 /* Management Interface Register */ 48 #define IHPHY_MII_MIR BME1000_REG(0, 21) 49 50 /* PHY Configuration Register */ 51 #define IHPHY_MII_CFG BME1000_REG(0, 22) 52 #define IHPHY_CFG_TX_CRS 0x8000 /* CRS transmit enable */ 53 #define IHPHY_CFG_FIFO_DEPTH 0x3000 /* Transmit FIFO depth*/ 54 #define IHPHY_CFG_DOWN_SHIFT 0x0C00 /* Automatic speed downshift mode */ 55 #define IHPHY_CFG_ALT_PAGE 0x0080 /* Alternate next page */ 56 #define IHPHY_CFG_GRP_MDIO 0x0040 /* Group MDIO mode enable */ 57 #define IHPHY_CFG_TX_CLOCK 0x0020 /* Transmit clock enable */ 58 59 /* PHY Control Register */ 60 #define IHPHY_MII_ECR BME1000_REG(0, 23) 61 #define IHPHY_ECR_LNK_EN 0x2000 /* Link enable */ 62 #define IHPHY_ECR_DOWN_SHIFT 0x1C00 /* Automatic speed downshift attempts */ 63 #define IHPHY_ECR_LNK_PARTNER 0x0080 /* Link Partner Detected */ 64 #define IHPHY_ECR_JABBER 0x0040 /* Jabber (10BASE-T) */ 65 #define IHPHY_ECR_SQE 0x0020 /* Heartbeat (10BASE-T) */ 66 #define IHPHY_ECR_TP_LOOPBACK 0x0010 /* TP loopback (10BASE-T) */ 67 #define IHPHY_ECR_PRE_LENGTH 0x000C /* Preamble length (10BASE-T) */ 68 69 /* Interrupt Mask Register */ 70 #define IHPHY_MII_IMR BME1000_REG(0, 24) 71 72 /* Interrupt Status Register */ 73 #define IHPHY_MII_ISR BME1000_REG(0, 25) 74 75 /* PHY Status Register */ 76 #define IHPHY_MII_ESR BME1000_REG(0, 26) 77 #define IHPHY_ESR_STANDBY 0x8000 /* PHY in standby */ 78 #define IHPHY_ESR_ANEG_FAULT 0x6000 /* Autonegotation fault status */ 79 #define IHPHY_ESR_ANEG_STAT 0x1000 /* Autonegotiation status */ 80 #define IHPHY_ESR_PAIR_SWAP 0x0800 /* Pair swap on pairs A and B */ 81 #define IHPHY_ESR_POLARITY 0x0400 /* Polarity status */ 82 #define IHPHY_ESR_SPEED 0x0300 /* Speed status */ 83 #define IHPHY_ESR_DUPLEX 0x0080 /* Duplex status */ 84 #define IHPHY_ESR_LINK 0x0040 /* Link status */ 85 #define IHPHY_ESR_TRANSMIT 0x0020 /* Transmit status */ 86 #define IHPHY_ESR_RECEIVE 0x0010 /* Receive status */ 87 #define IHPHY_ESR_COLLISION 0x0008 /* Collision status */ 88 #define IHPHY_ESR_ANEG_BOTH 0x0004 /* Autonegotiation enabled for both */ 89 #define IHPHY_ESR_PAUSE 0x0002 /* Link partner has PAUSE */ 90 #define IHPHY_ESR_ASYM_PAUSE 0x0001 /* Link partner has asymmetric PAUSE */ 91 92 #define IHPHY_SPEED_10 0x0000 93 #define IHPHY_SPEED_100 0x0100 94 #define IHPHY_SPEED_1000 0x0200 95 96 /* LED Control Register 1 */ 97 #define IHPHY_MII_LED1 BME1000_REG(0, 27) 98 99 /* LED Control Register 2 */ 100 #define IHPHY_MII_LED2 BME1000_REG(0, 28) 101 102 /* LED Control Register 3 */ 103 #define IHPHY_MII_LED3 BME1000_REG(0, 29) 104 105 /* Diagnostics Control Register */ 106 #define IHPHY_MII_DCR BME1000_REG(0, 30) 107 108 /* Diagnostics Status Register */ 109 #define IHPHY_MII_DSR BME1000_REG(0, 31) 110 111 #endif /* _DEV_IHPHY_MIIREG_H_ */ 112