Copyright (c) 1987 The Regents of the University of California.
All rights reserved.
This code is derived from software contributed to Berkeley by
Computer Consoles Inc.
Redistribution and use in source and binary forms are permitted
provided that the above copyright notice and this paragraph are
duplicated in all such forms and that any documentation,
advertising materials, and other materials related to such
distribution and use acknowledge that the software was developed
by the University of California, Berkeley. The name of the
University may not be used to endorse or promote products derived
from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED ``AS IS'' AND WITHOUT ANY EXPRESS OR
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE.
@(#)enpload.8 5.2 (Berkeley) 10/19/88
All rights reserved.
This code is derived from software contributed to Berkeley by
Computer Consoles Inc.
Redistribution and use in source and binary forms are permitted
provided that the above copyright notice and this paragraph are
duplicated in all such forms and that any documentation,
advertising materials, and other materials related to such
distribution and use acknowledge that the software was developed
by the University of California, Berkeley. The name of the
University may not be used to endorse or promote products derived
from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED ``AS IS'' AND WITHOUT ANY EXPRESS OR
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE.
@(#)enpload.8 5.2 (Berkeley) 10/19/88
ENPLOAD 8 ""
C 5 NAME
enpload - download firmware and initialize a CMC Ethernet controller
SYOPNSIS
/etc/enpload device [
files ]
DESCRIPTION
Enpload is used to download firmware and initialize a CMC
ENP-20 Ethernet controller.
The
device specified is a character device used to access the on-board
RAM which hosts the controllers operating firmware;
the
files arguments specify the firmware file(s) to load into this memory.
After
enpload deposits the specified firmware it starts the board running.
If no firmware is specified the board is just restarted.
Enpload must be run before a CMC controller can be used by the
system.
FILES
/dev/enp?ram special files for accessing ENP-20 memory
/etc/enpcode link-level firmware
"SEE ALSO"
enp(4), ifconfig(8C), rc(8)