Copyright (c) 1990 Regents of the University of California.
All rights reserved. The Berkeley software License Agreement
specifies the terms and conditions for redistribution.

@(#)autoconf.4 5.1 (Berkeley) 06/29/90

C 7 autoconf - diagnostics from the autoconfiguration code When UNIX bootstraps it probes the innards of the machine on which it is running and locates controllers, drives, and other devices, printing out what it finds on the console. This procedure is driven by a system configuration table which is processed by config (8) and compiled into each kernel.

Autoconfiguration on the HP300s is similar to that on the VAX, the primary difference is in the naming conventions. On the HP300, if devices exist which are not configured they will be ignored; if devices exist of unsupported type they will be ignored.

Normally, the system uses the disk from which it was loaded as the root filesystem. If that is not possible, a generic system will use ``rd0'' if it exists. If such a system is booted with the RB_ASKNAME option (see reboot (2)), then the name of the root device is read from the console terminal at boot time, and any available device may be used.

intro(4), boot(8), config(8)

4.3BSD for the HP300 in the distribution documentation package.

CPU type not configured

You tried to boot UNIX on a cpu type which it doesn't (or at least this compiled version of UNIX doesn't) understand.

hpib%d at sc%d, ipl %d

An HP-IB was found at sc%d (the select code) with ipl%d (interrupt priority level). UNIX will call it hpib%d.

%s%d: %s

%s%d at hpib%d, slave %d

An HP-IB disk or tape controller was found. For disks %s%d will look like ``rd0'', for tapes like ``ct0''. The %s in the first line will be a product type like ``7945A'' or ``9144''. The slave number comes from the address select switches on the drive.

grf0 csr 0x560000

grf%d at sc%d

A bit mapped display was found either at the ``internal'' address (first case) or at some ``external'' select code (second case). If it exists, the internal display will always be unit 0.

%s%d at sc%d, ipl %d flags %d

Another peripheral controller was found at the indicated select code and with indicated interrupt priority level. %s will be one of ``dca'' (single-port serial interfaces), ``dcm'' (four-port serial interfaces), or ``le'' (LAN cards). The slave number comes from the address select switches on the interface card.