Copyright (c) 1986 Regents of the University of California.
All rights reserved. The Berkeley software License Agreement
specifies the terms and conditions for redistribution.

@(#)vx.4 6.2 (Berkeley) 06/30/87

C 7 vx - VIOC-X communications multiplexor "device vx0 at vba? csr 0xfffe0000 vector vackint vcmdrsp vunsol" A VIOC-X provides 16 communication lines with partial modem control, adequate for UNIX dialup use. Each line attached to the VIOC-X communications multiplexor behaves as described in tty (4) and may be set to run at any of 16 speeds; see tty (4) for the encoding. /dev/tty[0-9][0-9]

/dev/ttyd[0-9a-f] dialups

tty(4) vx%d: vc proc err, ustat %x.

vx%d: vc uqual err, uqual %x.

vx%d: %d exceeds silo size.

vx%d: receiver overrun.

VIOC-BOP no. %d at %x. The system identified a vioc supporting the bit oriented protocol. The number %d is the board number assigned by the system while the address %x is the address of the command control block for the vioc.

vx%d: unknown type %x. The system encountered a vioc of unknown type during autoconfiguration.

vx%d: didn't respond to LIDENT. The device did not respond to the configuration command that sets the interrupt vectors and port configuration.

vx%d: %s%s, ports %d-%d. This is informatory message printed during autoconfiguration indicating the type of hardware present the port configuration.

vx%d: no buffers. All the command buffers were in use; this indicates the device is constipated for some reason.

vx%d: setq overflow. An attempt to append a command to an existing command buffer failed because the buffer was full or the hardware doesn't support this facility.

vx%d: cmd q overflow. An attempt to place a new command on the command queue failed because it was full. The device is either overloaded or hung up for some reason. If this happens, the system tries to reset the device to unwedge it.

vx%d INTR ERR type %x v_dcd %x. An error was returned by the device in response to some command. The command identifier and data carrier detect mask are printed followed by the contents of the command buffer in error.

vx%d: vcmdrsp interrupt. A command response interrupt was received from a bop (bit oriented protocol) vioc. This should not happen.

vx%d: cmdresp debug.

vx%d: vunsol from BOP. An unsolicited interrupt was received from a bop vioc. This should not happen.

vx%d: interrupt q overflow. The queue of pending interrupts to be delivered to the vioc is full. This is probably due to the vioc being wedged. The system resets the vioc if this occurs.

vx%d: reset.... The system attempted to reset the vioc.