Copyright (c) 1986 The Regents of the University of California.
All rights reserved.

Redistribution and use in source and binary forms are permitted
provided that the above copyright notice and this paragraph are
duplicated in all such forms and that any documentation,
advertising materials, and other materials related to such
distribution and use acknowledge that the software was developed
by the University of California, Berkeley. The name of the
University may not be used to endorse or promote products derived
from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED ``AS IS'' AND WITHOUT ANY EXPRESS OR
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

@(#)de.4 6.3 (Berkeley) 02/14/89

C 5 de - DEC DEUNA 10 Mb/s Ethernet interface "device de0 at uba0 csr 174510 vector deintr" The de interface provides access to a 10 Mb/s Ethernet network through a Digital Equipment UNIBUS Network Adapter (DEUNA).

Each of the host's network addresses is specified at boot time with an SIOCSIFADDR ioctl. The de interface employs the address resolution protocol described in arp (4) to dynamically map between Internet and Ethernet addresses on the local network.

The interface normally tries to use a ``trailer'' encapsulation to minimize copying data on input and output. The use of trailers is negotiated with ARP. This negotiation may be disabled, on a per-interface basis, by setting the IFF_NOTRAILERS flag with an SIOCSIFFLAGS ioctl.

de%d: hardware address %s. This is a normal autoconfiguration message noting the 6 byte physical ethernet address of the adapter.

de%d: oerror, flags=%b tdrerr=%b (len=%d). The hardware indicated an error in transmitting a packet to the cable. The status and error flags are reported.

de%d: ierror, flags=%b lenerr=%b (len=%d). The hardware indicated an error in reading a packet from the cable. The status and error flags are reported.

de%d: can't handle af%d. The interface was handed a message with addresses formatted in an unsuitable address family; the packet was dropped.

de%d: buffer unavailable. The interface received more packets than it had buffers allocated to receive them.

de%d: address change failed, csr0=%b csr1=%b. The interface was unable to reprogram its physical ethernet address. This may happen with very early models of the interface. This facility is used only when the controller is not the first network interface configured for XNS.

The following messages indicate a probable hardware error performing the indicated operation during autoconfiguration or initialization. The two control and status registers should indicate the nature of the failure. See the hardware manual for details.

de%d: reset failed, csr0=%b csr1=%b.

de%d: ppcb failed, csr0=%b csr1=%b.

de%d: read addr failed, csr0=%b csr1=%b.

de%d: wtring failed, csr0=%b csr1=%b.

de%d: wtmode failed, csr0=%b csr1=%b.

netintro(4), inet(4), arp(4)