All rights reserved. The Berkeley software License Agreement
specifies the terms and conditions for redistribution.
@(#)tm.4 6.1 (Berkeley) 05/15/85
"tape te0 at tm0 drive 0"
te%d: not online. An attempt was made to access the tape while it was offline; this message is written on the terminal of the user who tried to access the tape.
te%d: can't switch density in mid-tape. An attempt was made to write on a tape at a different density than is already recorded on the tape. This message is written on the terminal of the user who tried to switch the density.
te%d: hard error bn%d er=%b. A tape error occurred at block bn; the tm error register is printed in octal with the bits symbolically decoded. Any error is fatal on non-raw tape; when possible the driver will have retried the operation which failed several times before reporting the error.
te%d: lost interrupt. A tape operation did not complete within a reasonable time, most likely because the tape was taken off-line during rewind or lost vacuum. The controller should, but does not, give an interrupt in these cases. The device will be made available again after this message, but any current open reference to the device will return an error as the operation in progress aborts.