1 /* drreg.h 1.3 87/12/22 */ 2 3 /* 4 ------------------------------------------ 5 Must include <h/types.h> and <h/buf.h> 6 ------------------------------------------ 7 */ 8 9 #define DRINTV 0x9c /* Has to match with ml/scb.s */ 10 #define DRADDMOD 0x01 /* Addr modifier used to access TAHOE memory */ 11 #define DR_ZERO 0 12 #define DRPRI (PZERO+1) 13 14 #define DR_TICK 600 /* Default # of clock ticks between call 15 to local timer watchdog routine */ 16 #define DR_TOCK 2 /* default # of calls to local watch dog 17 before an IO or wait is determined to 18 have timeout */ 19 20 21 struct rsdevice { 22 ushort dr_cstat; /* Control & status registers */ 23 ushort dr_data; /* Input/Ouptut data registers */ 24 char dr_addmod; /* Address modifier for DMA */ 25 char dr_intvect; /* Interrupt vector */ 26 ushort dr_pulse; /* Pulse command register */ 27 ushort dr_xx08; /* Not used */ 28 ushort dr_xx0A; /* Not used */ 29 ushort dr_xx0C; /* Not used */ 30 ushort dr_xx0E; /* Not used */ 31 ushort dr_xx10; /* Not used */ 32 ushort dr_walo; /* Low DMA address register --when written-- */ 33 ushort dr_range; /* DMA range counter */ 34 ushort dr_ralo; /* Low DMA address register --when read-- */ 35 ushort dr_xx18; /* Not used */ 36 ushort dr_wahi; /* High DMA address register --when written-- */ 37 ushort dr_xx1C; /* Not used */ 38 ushort dr_rahi; /* High DMA address register --when read-- */ 39 }; 40 41 42 struct dr_aux { 43 struct rsdevice *dr_addr; /* Physical addr of currently active DR11 */ 44 struct buf *dr_actf; /* Pointers to DR11's active buffers list */ 45 unsigned int dr_flags; /* State: Hold open, active,... */ 46 ushort dr_cmd; /* Hold cmd placed here by ioctl 47 for later execution by rsstrategy() */ 48 ushort dr_op; /* Current operation: DR_READ/DR_WRITE */ 49 long dr_bycnt; /* Total byte cnt of current operation */ 50 /* decremented by completion interrupt */ 51 caddr_t dr_oba; /* original xfer addr, count */ 52 long dr_obc; 53 unsigned long 54 rtimoticks, /* No of ticks before timing out on no stall 55 read */ 56 wtimoticks, /* No of ticks before timing out on no stall 57 write */ 58 currenttimo; /* the number of current timeout call to 59 omrwtimo() */ 60 ushort dr_istat; /* Latest interrupt status */ 61 struct buf dr_buf; 62 63 /*ushort dr_time; /* # of ticks until timeout */ 64 /*ushort dr_tock; /* # of ticks accumulated */ 65 /*ushort dr_cseq; /* Current sequence number */ 66 /*ushort dr_lseq; /* Last sequence number */ 67 }; 68 69 /* Command used by drioctl() 70 */ 71 struct dr11io { 72 ushort arg[8]; 73 }; 74 75 #define RSADDR(unit) ((struct rsdevice *)drinfo[unit]->ui_addr) 76 77 /* Control register bits */ 78 #define RDMA 0x8000 /* reset DMA end-of-range flag */ 79 #define RATN 0x4000 /* reset attention flag */ 80 #define RPER 0x2000 /* reset device parity error flag */ 81 #define MCLR 0x1000 /* master clear board and INT device */ 82 #define CYCL 0x0100 /* forces DMA cycle if DMA enabled */ 83 #define IENB 0x0040 /* enables interrupt */ 84 #define FCN3 0x0008 /* func. bit 3 to device (FNCT3 H) */ 85 #define FCN2 0x0004 /* func. bit 2 to device (FNCT2 H) */ 86 /* also asserts ACLO FCNT2 H to device */ 87 #define FCN1 0x0002 /* func. bit 1 to device (FNCT1 H) */ 88 #define GO 0x0001 /* enable DMA and pulse GO to device */ 89 90 /* Status register bits */ 91 #define DMAF 0x8000 /* indicates DMA end-of-range */ 92 #define ATTF 0x4000 /* indicates attention false-to-true */ 93 #define ATTN 0x2000 /* current state of ATTENTION H input */ 94 #define PERR 0x1000 /* Set by external parity error */ 95 #define STTA 0x0800 /* STATUS A H input state */ 96 #define STTB 0x0400 /* STATUS B H input state */ 97 #define STTC 0x0200 /* STATUS C H input state */ 98 #define REDY 0x0080 /* board ready for cmd (dma not on) */ 99 #define IENF 0x0040 /* Interrupt enabled if on */ 100 #define BERR 0x0020 /* Set if bus error during DMA */ 101 #define TERR 0x0010 /* Set if bus timeout during DMA */ 102 #define FC3S 0x0008 /* State of FCN3 latch */ 103 #define FC2S 0x0004 /* State of FCN2 latch */ 104 #define FC1S 0x0002 /* State of FCN1 latch */ 105 #define DLFG 0x0001 /* 0 -> IKON-10083 *** 1 -> IKON-10077 */ 106 107 /* Pulse command register bits */ 108 #define SMSK 0x0040 /* pulse interrupt mask on: Set IENB */ 109 #define RMSK 0x0020 /* pulse interrupt mask off: Reset IENB */ 110 111 112 /* 113 * DR11 driver's internal flags -- to be stored in dr_flags 114 */ 115 #define DR_FMSK 0x0000E /* function bits mask */ 116 #define DR_OPEN 0x00001 /* This dr11 has been opened */ 117 #define DR_PRES 0x00002 /* This dr11 is present */ 118 #define DR_ACTV 0x00004 /* waiting for end-of-range */ 119 #define DR_ATWT 0x00008 /* waiting for attention interrupt */ 120 #define DR_ATRX 0x00010 /* attn received-resets when read */ 121 #define DR_TMDM 0x00020 /* timeout waiting for end-of-range */ 122 #define DR_TMAT 0x00040 /* timeout waiting for attention */ 123 #define DR_DMAX 0x00080 /* end-of-range interrupt received */ 124 #define DR_PCYL 0x00100 /* set cycle with next go */ 125 #define DR_DFCN 0x00200 /* donot update function bits until next go */ 126 #define DR_DACL 0x00400 /* defer alco pulse until go */ 127 #define DR_LOOPTST 0x02000 /* This dr11 is in loopback test mode */ 128 #define DR_LNKMODE 0x04000 /* This dr11 is in link mode */ 129 #define DR_NORSTALL 0x10000 /* Device is set to no stall mode for reads. */ 130 #define DR_NOWSTALL 0x20000 /* Device is set to no stall mode for writes. */ 131 #define DR_TIMEDOUT 0x40000 /* The device timed out on a stall mode R/W */ 132 133 /* 134 * DR11 driver's internal flags -- to be stored in dr_op 135 */ 136 #define DR_READ FCN1 137 #define DR_WRITE 0 138 139 /* 140 * Ioctl commands 141 */ 142 #define DRWAIT _IOWR('d',1,long) 143 #define DRPIOW _IOWR('d',2,long) 144 #define DRPACL _IOWR('d',3,long) 145 #define DRDACL _IOWR('d',4,long) 146 #define DRPCYL _IOWR('d',5,long) 147 #define DRDFCN _IOWR('d',6,long) 148 #define DRRPER _IOWR('d',7,long) 149 #define DRRATN _IOWR('d',8,long) 150 #define DRRDMA _IOWR('d',9,long) 151 #define DRSFCN _IOWR('d',10,long) 152 153 #define DRSETRSTALL _IOWR('d',13,long) 154 #define DRSETNORSTALL _IOWR('d',14,long) 155 #define DRGETRSTALL _IOWR('d',15,long) 156 #define DRSETRTIMEOUT _IOWR('d',16,long) 157 #define DRGETRTIMEOUT _IOWR('d',17,long) 158 #define DRSETWSTALL _IOWR('d',18,long) 159 #define DRSETNOWSTALL _IOWR('d',19,long) 160 #define DRGETWSTALL _IOWR('d',20,long) 161 #define DRSETWTIMEOUT _IOWR('d',21,long) 162 #define DRGETWTIMEOUT _IOWR('d',22,long) 163 #define DRWRITEREADY _IOWR('d',23,long) 164 #define DRREADREADY _IOWR('d',24,long) 165 #define DRBUSY _IOWR('d',25,long) 166 #define DRRESET _IOWR('d',26,long) 167 168 /* The block size for buffering and DMA transfers. */ 169 /* OM_BLOCKSIZE must be even and <= 32768. Multiples of 512 are prefered. */ 170 #define OM_BLOCKSIZE 32768 171 172 173 /* --- Define ioctl call used by dr11 utility device -- */ 174 175 #define DR11STAT _IOWR('d',30,struct dr11io) /* Get status dr11, unit 176 number is dr11io.arg[0] */ 177 #define DR11LOOP _IOR('d',31,struct dr11io) /* Perform loopback test */ 178 179 /* ---------------------------------------------------- */ 180 181