sys: Remove $FreeBSD$: one-line .c pattern

Remove /^[\s*]*__FBSDID\("\$FreeBSD\$"\);?\s*\n/

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of BSD-2-Clause.

Discussed with: pfg
MFC After: 3 days
Sponsored by: Netflix

show more ...

arm/arm64 freescale: Remove unused devclass arguments to DRIVER_MODULE.

arm: clean up empty lines in .c and .h files

Add mode selection to iMX6 IPU driver

- Configure ipu1_di0 tob e sourced from the VIDEO_PLL(PLL5) and hardcode
frequency to (455000000/3)Mhz. This value, further divided, can yield
frequencies c

Add mode selection to iMX6 IPU driver

- Configure ipu1_di0 tob e sourced from the VIDEO_PLL(PLL5) and hardcode
frequency to (455000000/3)Mhz. This value, further divided, can yield
frequencies close enough to support 1080p, 720p, 1024x768, and 640x480
modes. This is not ideal but it's an improvement comparing to the only
hardcoded 1024x768 mode.

- Fix memory leaks if attach method failed
- Print EDID when -v passed to the kernel

show more ...

Add a SPI driver for imx5 and imx6.

It can be compiled into the kernel with "device imx_spi" or loaded as a
module, which is also named "imx_spi".

sys/arm: further adoption of SPDX licensing ID tags.

Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error

sys/arm: further adoption of SPDX licensing ID tags.

Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.

The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.

show more ...

Add an ahci driver for imx6.

This was submitted by Rogiel Sulzbach (thank you!) but has a few last-minute
changes by me, mostly where the code interfaces to my still-utterly-deficient
imx6_ccm clock

Add an ahci driver for imx6.

This was submitted by Rogiel Sulzbach (thank you!) but has a few last-minute
changes by me, mostly where the code interfaces to my still-utterly-deficient
imx6_ccm clocks implementation. So blame me for any mistakes.

Submitted by: Rogiel Sulzbach <rogiel@rogiel.com>
Differential Revision: https://reviews.freebsd.org/D11177

show more ...

Add a driver for the imx6 EPIT timer that can be used as the system
timecounter instead of the GPT timer, freeing up the more flexible GPT
hardware for other uses. The EPIT driver is a standard (alw

Add a driver for the imx6 EPIT timer that can be used as the system
timecounter instead of the GPT timer, freeing up the more flexible GPT
hardware for other uses. The EPIT driver is a standard (always in the
kernel) driver, and the existing GPT driver is now optional and included
only if you ask for device imx_gpt.

show more ...

"Buses" is the preferred plural of "bus"

Replace archaic "busses" with modern form "buses."

Intentionally excluded:
* Old/random drivers I didn't recognize
* Old hardware in general
* Use of "bus

"Buses" is the preferred plural of "bus"

Replace archaic "busses" with modern form "buses."

Intentionally excluded:
* Old/random drivers I didn't recognize
* Old hardware in general
* Use of "busses" in code as identifiers

No functional change.

http://grammarist.com/spelling/buses-busses/

PR: 216099
Reported by: bltsrc at mail.ru
Sponsored by: Dell EMC Isilon

show more ...

Add CCM functions to enable HDMI framer and IPU units (video controller)

Reviewed by: andrew, ian
Differential Revision: https://reviews.freebsd.org/D4168

Replace magic numbers for CCGRx registers with more descriptive names

Enable cloks for all USDHC interfaces, previous value was USDHC 1-3 + USBOH3

Add the code necessary to run the imx6 chip at its lowest clock/power
operating point (396MHz/950mV).

Add support for audio transmitting, include drivers for:
o Digital Audio Multiplexer (AUDMUX)
o Smart Direct Memory Access Controller (SDMA)
o Synchronous Serial Interface (SSI)

Disable by default a

Add support for audio transmitting, include drivers for:
o Digital Audio Multiplexer (AUDMUX)
o Smart Direct Memory Access Controller (SDMA)
o Synchronous Serial Interface (SSI)

Disable by default as it depends on SDMA firmware.

Sponsored by: Machdep, Inc.

show more ...

Enable all the mmc/sd controllers, because there's no telling which ones
any given board will be using.

Yes, changing source is an unusually primitive power control implementation.

Unconditionally enable the clocks for all imx6 devices that we have drivers
for, or that are required to run the chip (such as busses). Turn off all
the devices we don't yet have drivers for.

Some

Unconditionally enable the clocks for all imx6 devices that we have drivers
for, or that are required to run the chip (such as busses). Turn off all
the devices we don't yet have drivers for.

Some day we will have a fully functional imx6 clock driver so that we can
manage clocks based on fdt data. This will have to do until then.

show more ...

Attach the imx6 CCM driver during BUS_PASS_CPU. It controls the clocks
for most on-chip devices and needs to be available before other drivers
start attaching and asking to have their clocks enabled.

Add a function to get the frequency of the AHB bus. Another stopgap
function until we have full clock support for imx6.

Stop calling imx51_ccm_foo() clock functions from imx6 code. Instead
define a few imx_ccm_foo() functions that are implemented by the imx51 or
imx6 ccm code. Of course, the imx6 ccm code is still m

Stop calling imx51_ccm_foo() clock functions from imx6 code. Instead
define a few imx_ccm_foo() functions that are implemented by the imx51 or
imx6 ccm code. Of course, the imx6 ccm code is still more a wish than
reality, so for now its implementations just return hard-coded numbers.

show more ...

Initialize the Low Power Mode bits to keep the ARM cores running during WFI.

Follow r261352 by updating all drivers which are children of simplebus
to check the status property in their probe routines.

Simplebus used to only instantiate its children whose status="okay"
but t

Follow r261352 by updating all drivers which are children of simplebus
to check the status property in their probe routines.

Simplebus used to only instantiate its children whose status="okay"
but that was improper behavior, fixed in r261352. Now that it doesn't
check anymore and probes all its children; the children all have to
do the check because really only the children know how to properly
interpret their status property strings.

Right now all existing drivers only understand "okay" versus something-
that's-not-okay, so they all use the new ofw_bus_status_okay() helper.

show more ...

Add stubbed-out imx6 support for clocks and power management. This
contains little more than a few stub functions required to keep the
linker happy, but it's enough to let early imx6 development pro

Add stubbed-out imx6 support for clocks and power management. This
contains little more than a few stub functions required to keep the
linker happy, but it's enough to let early imx6 development proceed.

show more ...

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of BSD-2-Clause.

Discussed with: pfg
MFC After: 3 days
Sponsored by: Netflix

show more ...

arm/arm64 freescale: Remove unused devclass arguments to DRIVER_MODULE.