/freebsd/contrib/llvm-project/llvm/lib/Target/PowerPC/ |
H A D | PPCRegisterInfoDMR.td | 21 // In addition to the above classes two consecutive DMR registers make a DMR 43 // A consecutive pair of DMR row registers. 80 // DMRROW pairs are consecutive pairs.
|
H A D | P9InstrResources.td | 814 // Requires consecutive Load and ALU pieces totaling 6 cycles. The Load and ALU 826 // Requires consecutive Load and ALU pieces totaling 6 cycles. The Load and ALU 836 // Requires consecutive Load and ALU pieces totaling 7 cycles. The Load and ALU 846 // Requires consecutive Load (4 cycles) and ALU (3 cycles) pieces totaling 7 859 // Requires consecutive Load and ALU pieces totaling 8 cycles. The Load and ALU 1109 // Cracked ALU instruction composed of three consecutive 2 cycle loads for a
|
/freebsd/contrib/llvm-project/llvm/lib/Target/ARM/ |
H A D | ARMRegisterInfo.td | 40 // Note: Code depends on these having consecutive numbers. 510 // These are needed by NEON instructions requiring two consecutive D registers. 516 // Register class representing a pair of consecutive D registers. 548 // Pseudo-registers representing 3 consecutive D registers. 554 // 3 consecutive D registers. 565 // (4 consecutive D registers). 582 // 4 consecutive D registers. 586 // Pseudo 512-bit registers to represent four consecutive Q registers. 590 // Pseudo 512-bit vector register class to model 4 consecutive Q registers 591 // (8 consecutive D registers). [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/input/touchscreen/ |
H A D | cyttsp.txt | 27 - active-interval-ms : the minimum period in ms between consecutive 30 - lowpower-interval-ms : the minimum period in ms between consecutive
|
H A D | cypress,cy8ctma340.yaml | 87 description: the minimum period in ms between consecutive 93 description: the minimum period in ms between consecutive
|
H A D | ads7846.txt | 54 ti,debounce-rep Additional consecutive good readings
|
/freebsd/sys/contrib/device-tree/Bindings/display/mediatek/ |
H A D | mediatek,od.yaml | 15 of pixels between consecutive frames to make LCD rotate faster.
|
/freebsd/sys/contrib/device-tree/Bindings/gpio/ |
H A D | cavium-octeon-gpio.txt | 44 /* The GPIO pin connect to 16 consecutive CUI bits */
|
/freebsd/sys/contrib/device-tree/Bindings/mfd/ |
H A D | mxs-lradc.txt | 16 - fsl,ave-delay: delay between consecutive samples. Allowed value is
|
H A D | atmel-tcb.txt | 19 counter width is 16 bits (at91rm9200-tcb), two consecutive
|
/freebsd/sys/contrib/device-tree/Bindings/display/ |
H A D | mipi-dsi-bus.txt | 59 - If the virtual channels that a peripheral responds to are consecutive, the 62 the number of consecutive virtual channels.
|
/freebsd/sys/contrib/device-tree/Bindings/hwmon/ |
H A D | adi,max31827.yaml | 51 Select how many consecutive temperature faults must occur before
|
/freebsd/sys/contrib/device-tree/Bindings/sound/ |
H A D | cs35l36.txt | 114 amount delay between consecutive volume attenuation steps when a brownout 129 between consecutive volume attenuation release steps when a brownout condition
|
H A D | cs35l33.txt | 57 cirrus,release-rate : The number of consecutive LRCLK periods before
|
/freebsd/crypto/openssl/doc/man3/ |
H A D | OPENSSL_instrument_bus.pod | 29 OPENSSL_instrument_bus2() on the other hand B<accumulates> consecutive
|
/freebsd/sys/contrib/device-tree/Bindings/phy/ |
H A D | phy-cadence-sierra.txt | 43 group is made up of consecutive lanes.
|
H A D | phy-cadence-sierra.yaml | 103 Number of lanes in this group. The group is made up of consecutive lanes.
|
/freebsd/sys/contrib/device-tree/Bindings/firmware/ |
H A D | intel,ixp4xx-network-processing-engine.yaml | 18 consecutive memory locations. They are all included in the same
|
/freebsd/sys/contrib/device-tree/Bindings/memory-controllers/ |
H A D | mediatek,smi-larb.yaml | 70 hardware id is not consecutive from its M4U point of view.
|
/freebsd/sys/contrib/device-tree/Bindings/media/ |
H A D | samsung-s5c73m3.txt | 51 be only consecutive ascending values.
|
/freebsd/sys/contrib/device-tree/src/mips/cavium-octeon/ |
H A D | octeon_3xxx.dtsi | 43 /* The GPIO pin connect to 16 consecutive CUI bits */
|
/freebsd/sys/contrib/device-tree/Bindings/spi/ |
H A D | spi-peripheral-props.yaml | 119 delay in nanoseconds inserted between two consecutive data frames.
|
/freebsd/sys/contrib/device-tree/Bindings/pci/ |
H A D | pci-msi.txt | 43 * length is a single cell describing how many consecutive RIDs are matched
|
/freebsd/sys/fs/nfsclient/ |
H A D | nfs_clvnops.c | 3805 bool consecutive, must_commit, tryoutcred; in nfs_copy_file_range() local 3904 consecutive = true; in nfs_copy_file_range() 3906 consecutive = false; in nfs_copy_file_range() 3960 ap->a_outcred, consecutive, &must_commit); in nfs_copy_file_range() 3965 ap->a_incred, consecutive, &must_commit); in nfs_copy_file_range() 3972 if (consecutive == false) { in nfs_copy_file_range() 3990 } else if (error == NFSERR_OFFLOADNOREQS && consecutive) { in nfs_copy_file_range() 3998 consecutive = false; in nfs_copy_file_range()
|
/freebsd/sys/contrib/device-tree/Bindings/mmc/ |
H A D | marvell,xenon-sdhci.txt | 72 Set the number of required consecutive successful sampling points
|