| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | ti,tlv320adcx140.yaml | 121 1 - GPIO1 is configured as a general-purpose output (GPO)
122 2 - (default) GPIO1 is configured as a device interrupt output (IRQ)
123 3 - GPIO1 is configured as a secondary ASI output (SDOUT2)
124 4 - GPIO1 is configured as a PDM clock output (PDMCLK)
125 8 - GPIO1 is configured as an input to control when MICBIAS turns on or
127 9 - GPIO1 is configured as a general-purpose input (GPI)
128 10 - GPIO1 is configured as a master clock input (MCLK)
129 11 - GPIO1 is configured as an ASI input for daisy-chain (SDIN)
130 12 - GPIO1 is configured as a PDM data input for channel 1 and channel 2
132 13 - GPIO1 is configured as a PDM data input for channel 3 and channel 4
[all …]
|
| H A D | cirrus,cs35l41.yaml | 86 External Boost must have GPIO1 as GPIO output. GPIO1 will be set high to
90 circuit using combined data from both amplifiers. GPIO1 should be
104 Boolean which specifies whether the GPIO1
110 Boolean which specifies whether the GPIO1 pin
117 Configures the function of the GPIO1 pin.
143 Note that the options are different from the GPIO1 pin.
|
| H A D | rt5668.txt | 21 0: using GPIO1 pin as dmic1 clock pin
|
| H A D | realtek,rt5677.yaml | 71 - 1 # GPIO1 for jd1.
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| H A D | max77620.txt | 34 and power-down delays (sequencing). GPIO1, GPIO2, and GPIO3 can be programmed
46 Each regulator, GPIO1, GPIO2, GPIO3, and 32KHz clock has a flexible power
117 1: Enables POK(Power OK) to control nRST_IO and GPIO1
121 If POK mapping is enabled for GPIO1/nRST_IO then,
122 GPIO1/nRST_IO pins are HIGH only if all rails
125 control) then, GPIO1/nRST_IO goes LOW.
|
| /linux/arch/sh/kernel/cpu/sh4a/ |
| H A D | setup-shx3.c | 185 GPIO0, GPIO1, GPIO2, GPIO3, enumerator
232 INTC_VECT(GPIO0, 0xe40), INTC_VECT(GPIO1, 0xe60),
267 DU, GPIO3, GPIO2, GPIO1, GPIO0, PAM, 0, 0,
303 GPIO2, GPIO1, GPIO0, IRM } },
|
| H A D | setup-sh7786.c | 482 GPIO0, GPIO1, enumerator
527 INTC_VECT(GPIO0, 0xea0), INTC_VECT(GPIO1, 0xec0),
597 HSPI, GPIO0, GPIO1, Thermal,
637 GPIO1, Thermal } },
|
| /linux/drivers/media/usb/dvb-usb/ |
| H A D | dib07x0.h | 7 GPIO1 = 2, enumerator
|
| /linux/drivers/pinctrl/ |
| H A D | pinctrl-xway.c | 116 MFP_XWAY(GPIO1, GPIO, STP, DFE, EBU),
157 static const unsigned ase_pins_stp[] = {GPIO1, GPIO2, GPIO3};
162 static const unsigned ase_pins_dfe_led0[] = {GPIO1};
244 MFP_XWAY(GPIO1, GPIO, EXIN, CBUS, MII),
280 static const unsigned danube_pins_exin1[] = {GPIO1};
419 MFP_XWAY(GPIO1, GPIO, EXIN, CBUS, SIN),
479 static const unsigned xrx100_pins_exin1[] = {GPIO1};
632 MFP_XWAY(GPIO1, GPIO, EXIN, CBUS, SIN),
686 static const unsigned xrx200_pins_exin1[] = {GPIO1};
888 MFP_XWAY(GPIO1, GPIO, NONE, EXIN, NONE),
[all …]
|
| H A D | pinctrl-lantiq.h | 108 GPIO1, enumerator
|
| /linux/arch/arm/boot/dts/rockchip/ |
| H A D | rk3128-xpi-3128.dts | 297 gpio-line-names = /* GPIO1 A0-A7 */
300 /* GPIO1 B0-B7 */
303 /* GPIO1 C0-C7 */
306 /* GPIO1 D0-D7 */
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | warp.dts | 253 GPIO1: gpio@ef600c00 { label
263 gpios = <&GPIO1 0 0>;
266 gpios = <&GPIO1 1 0>;
|
| /linux/drivers/net/wireless/realtek/rtl818x/rtl8187/ |
| H A D | rfkill.c | 26 gpio = rtl818x_ioread8(priv, &priv->map->GPIO1); in rtl8187_is_radio_enabled()
|
| /linux/include/linux/mfd/ |
| H A D | tps65010.h | 119 #define GPIO1 1 macro
|
| /linux/Documentation/devicetree/bindings/gpio/ |
| H A D | x-powers,axp209-gpio.yaml | 45 - GPIO1
|
| H A D | xylon,logicvc-gpio.yaml | 68 gpio-line-names = "GPIO0", "GPIO1", "GPIO2", "GPIO3", "GPIO4",
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | ste,nomadik.txt | 119 pins = "GPIO1", "GPIO3";
129 pins = "GPIO1";
|
| /linux/arch/arm/boot/dts/broadcom/ |
| H A D | bcm2835-rpi-cm1-io1.dts | 20 "GPIO1",
|
| H A D | bcm2837-rpi-cm3-io3.dts | 20 "GPIO1",
|
| /linux/Documentation/arch/arm/ |
| H A D | netwinder.rst | 32 0x0338 GPIO1
|
| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3399-gru-scarlet.dtsi | 432 gpio-line-names = /* GPIO1 A 0-7 */
442 /* GPIO1 B 0-7 */
452 /* GPIO1 C 0-7 */
462 /* GPIO1 D0 */
|
| H A D | rk3399-gru-chromebook.dtsi | 288 gpio-line-names = /* GPIO1 A 0-7 */
298 /* GPIO1 B 0-7 */
308 /* GPIO1 C 0-7 */
|
| H A D | rk3588s-indiedroid-nova.dts | 201 gpio-line-names = /* GPIO1 A0-A7 */
204 /* GPIO1 B0-B7 */
207 /* GPIO1 C0-C7 */
210 /* GPIO1 D0-D7 */
|
| H A D | rk3588-friendlyelec-cm3588-nas.dts | 248 /* GPIO1 A0-A7 */
251 /* GPIO1 B0-B7 */
254 /* GPIO1 C0-C7 */
257 /* GPIO1 D0-D7 */
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8mp-msc-sm2s-ep1.dts | 134 <MX8MP_IOMUXC_SAI1_RXC__GPIO4_IO01 0x19>, /* GPIO1 */
|