1 /* iommu.h: Definitions for the sun4m IOMMU. 2 * 3 * Copyright (C) 1996 David S. Miller (davem@caip.rutgers.edu) 4 * Adapted for Proll by Pete Zaitcev in 1999 (== made worse than original). 5 */ 6 7 /* #include <asm/page.h> */ 8 9 /* The iommu handles all virtual to physical address translations 10 * that occur between the SBUS and physical memory. Access by 11 * the cpu to IO registers and similar go over the mbus so are 12 * translated by the on chip SRMMU. The iommu and the srmmu do 13 * not need to have the same translations at all, in fact most 14 * of the time the translations they handle are a disjunct set. 15 * Basically the iommu handles all dvma sbus activity. 16 */ 17 18 /* The IOMMU registers occupy three pages in IO space. */ 19 struct iommu_regs { 20 /* First page */ 21 volatile unsigned long control; /* IOMMU control */ 22 volatile unsigned long base; /* Physical base of iopte page table */ 23 volatile unsigned long _unused1[3]; 24 volatile unsigned long tlbflush; /* write only */ 25 volatile unsigned long pageflush; /* write only */ 26 volatile unsigned long _unused2[1017]; 27 /* Second page */ 28 volatile unsigned long afsr; /* Async-fault status register */ 29 volatile unsigned long afar; /* Async-fault physical address */ 30 volatile unsigned long _unused3[2]; 31 volatile unsigned long sbuscfg0; /* SBUS configuration registers, per-slot */ 32 volatile unsigned long sbuscfg1; 33 volatile unsigned long sbuscfg2; 34 volatile unsigned long sbuscfg3; 35 volatile unsigned long mfsr; /* Memory-fault status register */ 36 volatile unsigned long mfar; /* Memory-fault physical address */ 37 volatile unsigned long _unused4[1014]; 38 /* Third page */ 39 volatile unsigned long mid; /* IOMMU module-id */ 40 }; 41 42 #define IOMMU_CTRL_IMPL 0xf0000000 /* Implementation */ 43 #define IOMMU_CTRL_VERS 0x0f000000 /* Version */ 44 #define IOMMU_CTRL_RNGE 0x0000001c /* Mapping RANGE */ 45 #define IOMMU_RNGE_16MB 0x00000000 /* 0xff000000 -> 0xffffffff */ 46 #define IOMMU_RNGE_32MB 0x00000004 /* 0xfe000000 -> 0xffffffff */ 47 #define IOMMU_RNGE_64MB 0x00000008 /* 0xfc000000 -> 0xffffffff */ 48 #define IOMMU_RNGE_128MB 0x0000000c /* 0xf8000000 -> 0xffffffff */ 49 #define IOMMU_RNGE_256MB 0x00000010 /* 0xf0000000 -> 0xffffffff */ 50 #define IOMMU_RNGE_512MB 0x00000014 /* 0xe0000000 -> 0xffffffff */ 51 #define IOMMU_RNGE_1GB 0x00000018 /* 0xc0000000 -> 0xffffffff */ 52 #define IOMMU_RNGE_2GB 0x0000001c /* 0x80000000 -> 0xffffffff */ 53 #define IOMMU_CTRL_ENAB 0x00000001 /* IOMMU Enable */ 54 55 #define IOMMU_AFSR_ERR 0x80000000 /* LE, TO, or BE asserted */ 56 #define IOMMU_AFSR_LE 0x40000000 /* SBUS reports error after transaction */ 57 #define IOMMU_AFSR_TO 0x20000000 /* Write access took more than 12.8 us. */ 58 #define IOMMU_AFSR_BE 0x10000000 /* Write access received error acknowledge */ 59 #define IOMMU_AFSR_SIZE 0x0e000000 /* Size of transaction causing error */ 60 #define IOMMU_AFSR_S 0x01000000 /* Sparc was in supervisor mode */ 61 #define IOMMU_AFSR_RESV 0x00f00000 /* Reserver, forced to 0x8 by hardware */ 62 #define IOMMU_AFSR_ME 0x00080000 /* Multiple errors occurred */ 63 #define IOMMU_AFSR_RD 0x00040000 /* A read operation was in progress */ 64 #define IOMMU_AFSR_FAV 0x00020000 /* IOMMU afar has valid contents */ 65 66 #define IOMMU_SBCFG_SAB30 0x00010000 /* Phys-address bit 30 when bypass enabled */ 67 #define IOMMU_SBCFG_BA16 0x00000004 /* Slave supports 16 byte bursts */ 68 #define IOMMU_SBCFG_BA8 0x00000002 /* Slave supports 8 byte bursts */ 69 #define IOMMU_SBCFG_BYPASS 0x00000001 /* Bypass IOMMU, treat all addresses 70 produced by this device as pure 71 physical. */ 72 73 #define IOMMU_MFSR_ERR 0x80000000 /* One or more of PERR1 or PERR0 */ 74 #define IOMMU_MFSR_S 0x01000000 /* Sparc was in supervisor mode */ 75 #define IOMMU_MFSR_CPU 0x00800000 /* CPU transaction caused parity error */ 76 #define IOMMU_MFSR_ME 0x00080000 /* Multiple parity errors occurred */ 77 #define IOMMU_MFSR_PERR 0x00006000 /* high bit indicates parity error occurred 78 on the even word of the access, low bit 79 indicated odd word caused the parity error */ 80 #define IOMMU_MFSR_BM 0x00001000 /* Error occurred while in boot mode */ 81 #define IOMMU_MFSR_C 0x00000800 /* Address causing error was marked cacheable */ 82 #define IOMMU_MFSR_RTYP 0x000000f0 /* Memory request transaction type */ 83 84 #define IOMMU_MID_SBAE 0x001f0000 /* SBus arbitration enable */ 85 #define IOMMU_MID_SE 0x00100000 /* Enables SCSI/ETHERNET arbitration */ 86 #define IOMMU_MID_SB3 0x00080000 /* Enable SBUS device 3 arbitration */ 87 #define IOMMU_MID_SB2 0x00040000 /* Enable SBUS device 2 arbitration */ 88 #define IOMMU_MID_SB1 0x00020000 /* Enable SBUS device 1 arbitration */ 89 #define IOMMU_MID_SB0 0x00010000 /* Enable SBUS device 0 arbitration */ 90 #define IOMMU_MID_MID 0x0000000f /* Module-id, hardcoded to 0x8 */ 91 92 /* The format of an iopte in the page tables */ 93 #define IOPTE_PAGE 0x07ffff00 /* Physical page number (PA[30:12]) */ 94 #define IOPTE_CACHE 0x00000080 /* Cached (in vme IOCACHE or Viking/MXCC) */ 95 #define IOPTE_WRITE 0x00000004 /* Writeable */ 96 #define IOPTE_VALID 0x00000002 /* IOPTE is valid */ 97 #define IOPTE_WAZ 0x00000001 /* Write as zeros */ 98 99 #define IOPERM (IOPTE_CACHE | IOPTE_WRITE | IOPTE_VALID) 100 #define MKIOPTE(phys) (((((phys)>>4) & IOPTE_PAGE) | IOPERM) & ~IOPTE_WAZ) 101 102 #define IOMMU_REGS 0x300 103